User manual KYOSHO EDGE540 REDBULL EP50 ARF

[. . . ] Install only the specified batteries in the correct polarity. Never dissassemble batteries as this may cause heat or damage and is dangerous. Keep antenna point away from people's faces and do not wave around. During and after operation, the motor and batteries will be hot. [. . . ] Also, disconnect and remove batteries from the model and the transmitter as batteries may overheat or leak causing damage. This can lead to accidents and is dangerous. Always attach and close hatch when running, or damage from flooding may result. Do not store this model in a high-temperature/humidity area or in direct sunlight. Only use genuine Kyosho parts and do not modify the model. Using other parts or making modifications may cause damage. Never put the charger and Ni-Cd battery near flammable material while charging as this may cause fires!Do not allow them to get wet as this can cause damage. Shorted circuits from batteries can cause fire so do NOT dissassemble or modify Ni-Cd batteries under any circumstances. Never dispose of in fire as batteries may explode and are dangerous. Adjusts rudder so boat will run straight. Keep the throttle trigger on the transmitter in neutral, move the throttle trim to its middle position, then push the set-up button once. Move the throttle trigger to its forward most position, then push the set-up button once. Move the throttle trigger to its backward most position (the same applies for boats), then push the set-up button once. Move the throttle trigger to neutral, then push the set-up button once. If the transmitter power is not switched ON, or the receiver is not responding, pushing the set-up button will not initiate the ESC (Electronic Speed Controller) program mode. While the set-up program is running, the motor will not rotate. During set-up, if the set-up button is not pushed within 4~5 seconds, the ESC program mode will quit automatically without saving any data. Note that some parts are not sold as spare parts!Some of the parts included are not available as spare parts. Power switch on the Hull or Transmitter is not turned ON. Transmitter batteries are wrong type or wrong polarity. [. . . ] Please read these instructions carefully before using this RC boat on salt water in order to prevent part of your model from salt water corrosion (and corrosion in general). Prior to starting your boat, please check carefully the following parts: Lubrication on this part of your boat prevents ware and also ensures minimal water penetration. Check the rubber seals on your linkages to ensure again that there are no water penetration issues and apply some grease if necessary to assist prevention. Check carefully your electronics compartment and insure proper seal on the cover. [. . . ]