User manual KYOSHO EP BLUESTREAK 800

[. . . ] If you find any defective or missing parts, contact your local dealer or our Kyosho Distributor. B " , µ This kit contains many screws in and other hardware different metric sizes and shapes. B Self-tapping (TP) screws cut threads into the parts when being tightened. [. . . ] [ <XeBbN' --§ With the speed control stick in neutral. I With the speed control stick pushed up. B Make sure the position is correct; then, glue into place. B , ð Make sure that there is no gap. B Glued surface should be free from any oil residues and dirt. B , ð Apply sponge tape around the entire rim, leaving no gaps. B Decals with no number apply any place. B , Ì , Ì The decal numbers between brackets are only for the opposite side. "x X Adjusting the running posture and the speed by adjusting the angle of propeller. B , ª , Make sure that there is no gap. ¨ 'á , ¢ Wind : light Waves : low · , µ Do not adjust the rudder beyond this point. B , K , Ì OE¯ , Ì , ð In order to avoid accidents and personal injury, be sure to observe the following: With R/C boats, discover a new world of pleasure. Wheth- r you run your boat on lakes, rivers or elsee where, take precautionary measures to avoid accidents. B Do not put your hands or any objects into rotating parts, as this could result in serious accidents!B The motor and Ni-Cd battery get hot from run-ning. Do not touch them for a while after running. [. . . ] B Make sure screws and nuts are securely tightened and other parts are not worn. Repair the wiring should cords be damaged or drag into rotating parts. Should servo cords and the receiver antenna be damaged, return them to the manufacturer for repair. [. . . ]