User manual KYOSHO EP CALIBER 400 EXPLODED VIEW

[. . . ] 8 Make sure the servos move according to your transmitter inputs. Before assembling, please read the following carefully: Oe First, read this instruction manual and understand the modelÕs con- truction. Should parts be missing, immediately contact the retail shop or your nearest Kyosho distributor. Oe not take the wrong screw or small part. [. . . ] B , , ð , é Move the piston up and down to get rid of air bubbles. B , ³ , µ W j Make sure the servo is set to neutral before fitting servo horn. [ Disconnect Ni-Cd battery when it is not in use. B / Put them together with adhesive after removing the wheel from chassis. B , µ After fitting them together, pour instant glue along the seam. B , µ After fitting them together, pour instant glue along the seam. B Before painting, use a neutral detergent to remove any oil residues and dirt. L Refer to the pictures on the box for the color scheme. B After painting, remove the protective film from the body shell. [ "à Paint the body shell from the inside using KyoshoÕs spray colors. B , Ì , Ì The decal numbers between brackets are only for the opposite side. As long as the problem is not corrected, do not operate it. This may lead to further trouble and unforeseen acci- ents!WARNING: In order to avoid accidents and personal injury, be sure to observe the following: Carefully read the instructions on the Ni-Cd battery and charger before use!Never charge near inflammable material as the NiCd battery and charger get hot!Make sure the cord of a Ni-Cd battery never interferes any moving parts!Do not dispose of it into the usual waste stream!Oe not put fingers or any objects inside rotatDo ing and moving parts! Oe Right after use, do not touch the electric motor or Ni-Cd battery, as they will be hot!Does the car's steering react according to your transmitter inputs?Does the speed controller respond according to your transmitter inputs?Make sure screws and nuts are securely tightened and parts are not worn. [. . . ] Make connectors tighter with minus screwdriver. Wheels hardly rotate/do not rotate at all. Even when releasing throttle, car continues to run. Should speed controller not return to neutral, readjust linkages as per instruction manual. [. . . ]