User manual KYOSHO EP JET A-6 INTRUDER DF55 PIP

[. . . ] The Throttle Stop Screw is used to adjust idle speed of the engine. To increase the idle speed, turn Screw to the right (clockwise). Try to set the engine's idle speed as low as possible without the engine stopping. [. . . ] Try to set the engine's idle speed as low as possible without the engine stopping. This is a screw to adjust Air/Fuel Mixture at slow engine speed. Screw is set at the factory already so start engine as it is. If you moved screw, set it again as shown(screw head comes out 0. If the car does not accelerate Quickly, turn screw clockwise. If the rotation of the engine does not come down smoothly, turn screw counterclockwise. For starting the engine, take the starter knob and pull it quickly. However, do not pull past 50cm because the rope or the spring inside the recoil starter might tear. Check the radio batteries and be sure the model moves according to your inputs. Do not run the engine at full throttle when it is out of the water (no load). Because it can become very hot, do not touch the engine once it is started or after finishing running it. fuel for GP models mainly contains methanol. Never expose fuel to direct sunlight and always store it in safe places out of children's reach. If getting into eyes or if swallowed, wash out or induce a lot of water and immediately consult a physician. Keep hands and any objects away from rotating parts. Do not fail to install an air cleaner If the boat or the radio equipment is not functioning or responding properly, stop the boat to investigate, repair or adjust before continuing to operate. [. . . ] Keep hands and any objects away from rotating parts. Do not fail to install an air cleaner If the boat or the radio equipment is not functioning or responding properly, stop the boat to investigate, repair or adjust before continuing to operate. After running, wipe down and remove all fuel; exhaust oil; dirt and water, then lubricate with oil. [. . . ]