User manual KYOSHO EP JET F-4 PHANTOM DF55 PIP

[. . . ] Cutting along curved lines never was so easy!1 Insert the AA-size dry batteries into the transmitter. 3 Insert the AA-size dry batteries into the battery box. 9 Make sure the servos move according to your transmitter inputs. [. . . ] B , µ After fitting them together, pour instant glue along the seam. ô Before painting, use a neutral detergent to remove any oil residues and dirt. L Refer to the pictures on the box for the color scheme. [ "à Paint the body shell from the inside using KyoshoÕs spray colors. [ After painting, remove the protective film from the body shell. B/ Decals can be placed where you prefer. B , È , Although the slipper clutch is factory-adjusted some readjustments may be necessary (e. If necessary, proceed as explained below : Die Slipperkupplung ist werksseitig voreingestellt. If the slipper clutch slips too much and the car does not start off, tighten the 4mm nylon nut. B , µ `¬ , « , Á `¬ As a thumb rule, set the slipperclutch to slip a little from a dead stop. B The more the slipper clutch slips, the more heat is generated. Ensure the fuel lining is proof, with no cracks. Ensure nobody is on your frequency at the same time. B ^µ Since exhausts and fuel vapors are noxious to health, use fuel only outdoors!Engine starting becomes easier when raising the throttle trim. Start the engine in either of the following ways: Starten Sie den Motor auf eine der dargestellten Arten. Move the throttle control a little up to enhance engine run up. O When rpm become stable, lower the throttle control and trim, and disconnect the glow plug heater. When fuel is coming up to this point, push the primer button one more time. Do not touch them during and right after operation!B " " , ª Engine starting becomes easier when some fuel enters the carburetor and spreads through the engine after pulling the recoil starter 2 to 3 times. B , Ì C After stopping the engine, first switch off the receiver, then the transmitter. [. . . ] Note that for normal running, the needle valve is screwed out 10¡~20¡ from the valve's optimal setting position!B , ª When the throttle control is in neutral, the car does not speed off even when not applying the brakes!Before putting your car aside, draw out any fuel from the tank. Next, restart the engine to combust remaining fuel. [. . . ]