User manual KYOSHO GYRO UNIT

[. . . ] To reduce the risk of fire, explosion, electric shock, or personal injury when using your hob, follow these basic safety precaution Do NOT attempt. Unplug the power plug from the wall socket. Make sure the machine is grounded to prevent electric shock. Note Important 2_ using this manual GYRO UNIT_XEU_00343A_EN. indd 2 28/02/2011 11:23:15 safety instructions The safety aspects of this appliance comply with all accepted technical and safety standards. [. . . ] For protection against moisture, all cut surfaces are to be sealed with a suitable sealant. On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout. On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive. Ensure that the seal is correctly seated against the work surface without any gaps. Additional silicon sealant must not be applied; this would make removal more difficult when servicing. The hob must be pressed out from below when removed. A board is to be installed underneath the hob. The ventilation gap between the worktop and front of the unit underneath it must not be covered. · · · · · · · · · · · 12_ installing the hob GYRO UNIT_XEU_00343A_EN. indd 12 28/02/2011 11:23:16 CONNECTING TO THE MAINS POWER SUPPLY Before connecting, check that the nominal voltage of the appliance, that is, the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. Shut off power to circuit before connecting wires to circuit. WARNING INSTALLING THE HOB The heating element voltage is AC 230 V~. Control and function indicators : Digital displays and indicator lights provide information about settings and activated functions, as well as the presence of residual heat in the various cooking zones. Safety shutoff : A safety shutoff ensures that cooking zones switch off automatically after a period of time if the setting has not been changed. Residual heat indicator : An icon for residual heat appears in the display if the cooking zone is so hot that there is a risk of burning. Power Boost : Use this function to heat up the contents of the pan faster than maximum power level ` '. (The display will show ` '. ) Auto Pan-Detection : Each cooking zone incorporates an automatic pan-detection system, the system is calibrated in order to recognize pans of a diameter just slightly smaller than the cooking zone. Pans must always be placed centrally on each cooking zone. Digital displays : The four display fields are assigned to the four cooking zones. They show the following information: the appliance has been switched on, to , selected heat settings, residual heat, the child lock is activated; and error message, the touch sensor button has been touched for longer than 60 seconds. error message, when the hob is overheated because of abnormal operation. (example : operation with empty cookware) error message, cookware is unsuitable or too small or no cookware has been placed on the cooking zone. Keep warm : Use this function to keep warm cooked food. [. . . ] Keep all items and materials that could melt, for example, plastics, aluminium foil and oven foils, away from the ceramic glass surface. If something of this nature melts onto the hob, it must be removed immediately with a scraper. · · · · 30_ cleaning and care GYRO UNIT_XEU_00343A_EN. indd 30 28/02/2011 11:23:21 warranty and service FAQS AND TROUBLESHOOTING WARRANTY AND SERVICE A fault may result from a minor error that you can correct yourself with the help of the following instructions. Do not attempt any further repairs if the following instructions do not help in each specific case. WARNING Repairs to the appliance are to be performed only by a qualified service technician. Improperly effected repairs may result in considerable risk to the user. [. . . ]