User manual KYOSHO LAZER ZX-5 FS

[. . . ] How to read the instruction manual: Please note them during the entire assembly. Æ , All parts except screws are identified by key numbers. For purchasing spare parts, find the key no. Of the part needed in the spare part list and refer to the left column to look up the corresponding order no. [. . . ] Before using them, check the screws on the true-to-scale diagrams on the left side in each assembly step. B , Self-tapping (TP) screws cut threads into the parts when being tightened. Excessive force may permanently damage parts when tightening TP screws. It is recommended to stop tightening when the part is attached or when some resistance is felt after the threaded portion enters the plastic. B "j Secure parts 3 and 10 in place with two flat head screwdrivers and rotate the differential case until it becomes tight. When running the car, the differential must be tight, otherwise it may be damaged. If part 3 rotates into the opposite direction to part 10 , no further adjustment is necessary. If part 3 does not rotate, screw 13 is too tight. In this case, gradually loosen screw 13 until part 3 rotates. Complete the shock assembly in the order 30 , 35 and 19 . B Pull down the piston and slowly fill in oil. This may lead to further trouble and unforeseen accidents!B , K , Ì OE¯ , Ì , ð WARNING: in order to avoid accidents and personal injury, be sure to observe the following: Do NOT put fingers or any objects inside rotating and moving parts!Rotating / moving at high speed, you may be seriously injured! Before charging, please carefully read the explanations of the Ni-Cd battery and charger unit!While charging, the Ni-Cd battery and charger unit get hot!NEVER charge on top of or near easily inflammable material as this will result in fires!Ensure the cords do NOT trail into rotating and moving parts! After operation, the electric motor and Ni-Cd battery are hot!You may burn yourself seriously touching them!Ni-Cd batteries use heavy metals that are noxious to health!NEVER throw them into fires as they will explode! [. . . ] NEVER throw them into fires as they will explode!Do NOT dispose of them into the usual waste stream!B Make sure the model steers according to your transmitter inputs. B Make sure the speed (electric speed controller) changes according to your transmitter inputs. [. . . ]