User manual KYOSHO MEGA FORCE

[. . . ] Oe First-time builders should seek the advice of experienced modellers before commencing assembly and if they do not fully understand any part of the construction. Oe Assemble this kit only in places out of children's reach! Oe Take enough safety precautions prior to operating this model. You are responsible for this model's assembly and safe operation! [. . . ] Always use same kind and fresh new batteries. B , Ì `Î , Ì The decal numbers between brackets are only for the opposite side. B 'è Bind them together with tape. B / Check every time before driving / Vor jedem Fahrbetrieb prüfen!If the antenna is not firmly fixed, it can cause the car to go out of control Auf feste Verschraubung der Antenne im Gehäuse achten!B For adjusting the front tires left and right. B , , Keep the front tires in the air while adjusting the steering trim. B , , Keep the front tires in the air while adjusting the steering trim. B Operate the steering wheel to check if the front tires move correctly. B Precisely adjust the steering trim in case the front tires are not straight when the steering wheel is placed at neutral position. B , ª , à * Amount of front tire movement varies according to the amount of the steering wheel movement. If the wheel is turned all the way left or right, the front tires will also steer all the way right or left. B "F, µ If turning the transmitter wheel causes the front tires to move in the direction opposite to that shown in the diagram, change the position of the Servo Reversing Switch (see page 6). B "F, µ If forward and reverse are opposite, see if your transmitter has a servo reversing switch. ­ñ3/4SJ, ¢ , Ä , ¢ , é It should be opened approximately 3/4. If disassembling engines carelessly, their original performance may be lost!Ensure all moving parts move without binding. Ensure the fuel lining is proof, with no cracks. Ensure nobody is on your frequency at the same time. [ , è Power on the transmitter first, then the receiver. [. . . ] [ C , Adjust in the order 1 and 2 once the break-in is completed. B v " " , ð Start the engine as explained in the chapter <ENGINE STARTING> and run your car. B ^Ê'u Watch the speed of your car running down a straight with the throttle control moved to high. When screwing in the needle valve 10 ~20 , speed increases. [. . . ]