User manual KYOSHO MINIUM SUKHOI SU31

[. . . ] Also use to exit the OSD menu or return to the previous menu. Navigate buttons (Up-Down buttons) Moves from one menu item to another vertically or adjusts selected menu values. Adjust buttons (Left-Right buttons) / Volume buttons Moves from one menu item to another horizontally or adjusts selected menu values. When OSD is not on the screen, press the button to adjust volume. [. . . ] - Teletext Buttons SOURCE TTX/MIX Note This function does not work for this LCD Display. MTS/DUAL MTSYou can select MTS (Multichannel Television Stereo) mode. Audio Type FM Stereo Mono Stereo SAP DUALSTEREO/MONO, DUAL l / DUAL ll and MONO/NICAM MONO/NICAM STEREO can be operated depending on the MTS/S_Mode Mono Mono !" Stereo Mono !" SAP Default Manual Change Mono Introduction broadcasting type by using the DUAL button on the remote control while watching TV. Note Enabled when a TV tuner box is connected. ENTER/PRE-CH This button is used to return to the immediately previous channel. Note Enabled when a TV tuner box is connected. MUTE Pauses (mutes) the audio output temporarily. This is displayed on the lower left corner of the screen. The audio comes back on if MUTE or - VOL + is pressed in the Mute mode. Note Enabled when a TV tuner box is connected. TV Allows you to watch an analogue or digital TV. Press SOURCE on the product or remote control and select "AV". Then, start the Camcorders with a tape inserted. 2. 3. 4. Note The audio-video cables shown here are usually included with a Camcorder. (If not, check your local electronics store. ) If your camcorder is stereo, you need to connect a set of two cables. Connections Connecting Using a HDMI Cable 1. 2. Connect an HDMI cable to [HDMI IN 2 (MAGICINFO)] or [HDMI IN 1] on the product and the HDMI output port on a digital device. Press SOURCE on the product or remote control and select "HDMI1 / HDMI2" Note In HDMI mode, only PCM format audio is supported. Connecting Using a DVI to HDMI Cable Connect a DVI-HDMI cable to [HDMI IN 2 (MAGICINFO)] or [HDMI IN 1] and the DVI output port on the digital device. Contact a Service Center for problems that you cannot solve by yourself. Self-Test Feature Check 1. Turn off both your computer and the LCD Display. Unplug the video cable from the back of the computer. The figure shown below ("No Signal") appears on a black background when the LCD Display is working normally even though no video signal is detected: While in the SelfTest mode, the LED power indicator remains green and the figure moves around on the screen. If your LCD Display screen remains blank after using the previous procedure, check your video controller and computer system; your LCD Display is functioning properly. Turn off your LCD Display and reconnect the video cable; then turn on both your computer and the LCD Display. Warning Messages You can even view the screen at a resolution of 1366 x 786. [. . . ] The LCD Display is using its power management system. Press any key on the keyboard. Problems related to Audio Note Problems related to audio signals and their solutions are listed below. Ensure that the audio cable is firmly connected to both the audio-in port on your LCD Display and the audio-out port on your sound card. (Refer to the Connecting a Computer) A: Q: A: A: Q: A: Check the volume level. [. . . ]