User manual KYOSHO MITSUBISHI LANCER EVOLUTION X PARTS LIST

[. . . ] Mention of software products manufactured by other companies does not necessarily constitute endorsement by the manufacturer . While all reasonable efforts have been made to make this document as accurate and helpful as possible, we make no warranty of any kind, expressed or implied, as to the accuracy or completeness of the information contained herein. The most up-to-date drivers and manuals are available from the web site: http://www. www. okiprintingsolutions. com Trademark Information Oki and Microline are registered trademarks of Oki Electric Industry Company Ltd. Apple, Macintosh and Mac OS are registered trademarks of Apple Computers Inc. [. . . ] For details on how to set the IP address and the port, refer Printer Configuration. > The printer web page allows more detailed settings. Settings of the workstation Set the printer in the workstation. Refer to: "Setting Up the Workstation" on page 29 NOTE MITSUBISHI LANCER EVOLUTION X Network Guide> 28 SETTING UP THE WORKSTATION This section explains the settings of Solaris 2. x workstation for printing. BEFORE SETUP Before setting up the workstation, check the following: · The setup procedures and commands may vary according to different versions of OS. Refer to the manuals that came with the workstation for details. To setup the printer, the user must be a superuser. Contact your network administrator to perform the setup if you do not have the authority of a superuser. Check the IP address set up for the printer in advance. Be cautious as an incorrect IP address may cause severe errors. Before performing any network setup (such as the IP address) to a host running under NIS (Network Information Service), consult the NIS administrator. · · · EXAMPLES OF SETTINGS FOR SOLARIS 2. X The examples below show printer settings for Solaris 2. 6 where the printer host name is printer1. Registering a printer (printer name: P001) supporting the PostScript language #lpadmin -p P001 -s printer1\!PS 2. Files that come after the 32nd files will be ignored. MITSUBISHI LANCER EVOLUTION X Network Guide> 31 Sample To print a file named "file1" to a printer set up as "P001", enter the following command: %lp -d P001 file1 To output three copies of "file1" and "file2" to "P001", enter the following: $lp -d P001 -n3 file1 file2 DELETE (CANCEL) This cancel command is used to delete print data which has been sent to print. Command Format cancel [Printer name] [Job Number] Command Options The following command options are available: Printer name This option specifies the printer name. The "cancel" command can be effectively used with the combined use of -a, -e and -u as shown below. This option is invalid in the non-spool mode. -a Deletes all the print data, sent by a user who issues this command, from the data which has been received by a specified printer. -e Deletes all the print data received by a specified printer. -u user name Deletes all the print data sent by a specified user and received by a specified printer. MITSUBISHI LANCER EVOLUTION X Network Guide> 32 JOB NUMBER This option specifies the job number of the print data to be deleted. These numbers can be checked by issuing a "lpstat" command. This option is invalid in the non-spool mode. Precautions · Print data that consists of multiple files sent in one print instruction cannot be deleted file by file. All the files will be deleted at one go. [. . . ] Cause Verification Action MITSUBISHI LANCER EVOLUTION X Network Guide> 59 SETTING IP ADDRESS When the printer is connected to the network, it retrieves the IP address automatically from the DHCP server once it is switched on. If the DHCP server is not available or not in use, use one of the following methods to retrieve and set the IP address. · Set the IP address from the control panel · Use the IP address Setup Tool in the CD-ROM bundled with this printer. Important: · When using the DHCP server, use WINS (Windows Internet Name Service) server at the same time. [. . . ]