User manual KYOSHO MRO3M RM TYPE INSTRUCTIONS SHEET

[. . . ] Check the illustrations & use the correct part for each step of assembly. Should parts be missing, immediately contact the retail shop or your nearest Kyosho distributor. B , 'è , r , ª When tightening a self-tapping (TP) screw: continue tightening until fastened correctly, even if screw is hard to turn. However, do not overtighten it as the plastic thread inside the part may strip! [. . . ] B( G S15PR ) Make sure the shim is held flat between the engine and drive washer (GS15PR). The decal numbers between brackets are only for the opposite side. B , K , Ì OE¯ , Ì , ð In order to avoid accidents and personal injury, be sure to observe the following: Discover a new world of pleasure with R/C boats. Wheth- r you run your boat on lakes, rivers or elsee where, take precautionary measures to avoid accidents. B < , ± , µ NEVER use fuel indoors or in places with open fires and sources of heat!B Store fuel ONLY in cool, dry and dark places out of childrenÕs reach!B Do NOT dispose of empty fuel cans into a fire!Do not put your hands or any objects into rotating parts, as this could result in serious accidents!Vapors and exhausts are very noxious and dangerous to your health!B Right after use, do NOT touch equipment on the model such as the engine and muffler, because they generate high temperatures!You may burn yourself seriously by touching them!B When tightening the needle valve further, exhausts become in-visible and rpm decrease. Running the engine with this setting will damage it. Note that for normal running, the needle valve is unscrewed 10¡~20¡ from the valveÕs optimal setting position!B Switch the transmitter ON first, then the receiver. If you make it run for over 5 seconds, the starter will generate heat or even set on fire. B O , Put fuel in fuel tank and push the Choke Button to send fuel into the carburetor. 2V battery for more than 5 seconds at a time. If the starter is working properly and the engine still doesn't start, send a little more fuel to the caburetor by pushing the Choke Button a few more times. Once the engine is running, quickly cease starting the engine. ¦ Be careful not to run the engine at too high RPM. Also when the engine is being started, the glow plug is being heated automatically so please do not try to heat the plug any other way. [. . . ] Start the engine and see the condition of the plug. Then, open the caburetor about 2mm and start again. Glow Plug, widen inside of Plug Cap (1) with tools such as a driver. Next, restart the engine to combust remaining fuel. [. . . ]