User manual KYOSHO MZW1 BALL BEARING SET INSTRUCTIONS SHEET

[. . . ] 3 Insert the AA-size dry batteries into the battery box. 9 Make sure the servos move according to your transmitter inputs. Before assembling, please read the following carefully: Oe First, read this instruction manual and understand the model's con-struction. Should parts be missing, immediately contact the retail shop or your nearest Kyosho distributor. [. . . ] In case of using Ni-Cd battery and small type receiver. [ , « Position where brake starts working. B Before painting, use a neutral detergent to remove any oil residues and dirt. L Refer to the pictures on the box for the color scheme. [ After painting, remove the protective film from the body shell. B Paint the body shell from the inside using Kyosho's spray colors. B , Ì , Ì The decal numbers between brackets are only for the opposite side. B Always run your car with the body shell fitted!Avoid changing the running direction too often and too abruptly. Do not run your car on ground: · , ¬ , È , ¢ , ± , Æ Do not loosen too much since will Swingshaft fall out. , É , , , , Gives rear tires more grip when entering corners. Ensure nobody is on your frequency at the same time. B ^µ Since exhausts and fuel vapors are noxious to health, use fuel only outdoors!Engine starting becomes easier when raising the throttle trim. Start the engine in either of the following ways: Starten Sie den Motor auf eine der dargestellten Arten. [ , é Put some fuel into the carburetor. B AN , è *Remove the air cleaner once, place your finger on the carburetor. Move the throttle control a little up to enhance engine run up. O When rpm become stable, lower the throttle control and trim, and disconnect the glow plug heater. B " " , ª Engine starting becomes easier when some fuel enters the carburetor and spreads through the engine after pulling the recoil starter 2 to 3 times. Do not touch them during and right after operation!B , Ì C After stopping the engine, first switch off the receiver, then the transmitter. [. . . ] B When screwing the needle valve further in, exhausts become invisible and rpm decrease. Running the engine with this setting damages the engine. Note that for normal running, the needle valve is screwed out 10 ~20 from the valve's optimal setting position!B , ª When the throttle control is in neutral, the car does not speed off even when not applying the brakes! [. . . ]