User manual KYOSHO NISSAN FAIRLADY Z NISMO S-TUNE

[. . . ] 1 Center output tray Print jobs are output here with printed side facing down. 4 Paper level indicator Indicates the level of the remaining paper in the 550-sheet paper tray. 8 Extension output tray Pull this tray out to print on paper larger than Letter. Place the machine on a level and sturdy surface that can withstand the machine weight, 22. [. . . ] NOTE When the optional offset catch tray is installed, fold the tray first before opening the cover. Do not touch any parts inside the printer. NOTE If the offset catch tray is folded as in Step 1, close the cover and then return the tray to its original position. Do not touch any parts inside the printer. Take the drum-toner cartridge out of the packaging box and shake it seven or eight times as shown in the diagram. For a parallel cable, lift up the wire clip on both sides to secure it after it has been inserted into the connector. When pulling out the seal, pull it out horizontally. The tape might break if it is pulled out diagonally. After the seal has been pulled out, do not shake or bump the drum-toner cartridge. This section explains how to load Letter size plain paper in portrait orientation in the paper tray. When connecting the power cord, take heed of the information given in "Safety precautions" on page 3. Configure the paper size when custom size paper is loaded. Press the < > or < > button until the required language is displayed, then press the <FEED/SELECT> button. Press the <MENU> button to complete the language setting. Level downwards) or < > button (moves one level upwards) To check whether the printer is correctly installed, use the control panel to print the [System Settings List]. NOTE If you have made a mistake when operating the control panel, press the <MENU> button to restart. Press the < > or < > button until [Report/List] is displayed, then press the < > button. Press the < > or < > button until [System Settings] is displayed, then press the < > button. > [Rear Output Tray] is displayed in the column for Output Device even when the rear tray is not installed. > Reports/lists cannot be output to the face up (rear) tray. When the face up (rear) tray is installed, lower the face up (rear) tray output lever. Switch between < > button (displays the menus or items in the previous menu or item) or same level < > button (displays the next menu or item) Move the cursor (_) < > button (moves to the of the setting value to right) or < > button the right or left (moves to the left) Confirm setting <FEED/SELECT> button When you press the MENU button on the control panel, you enter the printer's menu system. [. . . ] After completing the installation procedure, verify that the printer is working correctly by printing a document from an application. Click the utilities and downloads you want to install and follow the instructions. If your printer has an optional second paper tray or Hard Disk Drive installed, you must enter the driver and activate it. Click Available Tray and select your paper tray from the drop-down menu Turn the Printer ON and wait for the print server status light (2) to stop blinking. [. . . ]