User manual KYOSHO NISSAN SKYLINE GT-R V-SPEC II NUR PARTS LIST

[. . . ] While all reasonable efforts have been made to make this document as accurate and helpful as possible, we make no warranty of any kind, expressed or implied, as to the accuracy or completeness of the information contained herein. The most up-to-date drivers and manuals are available from the Oki Data website http://www. okidata. com and http://my. okidata. com. Copyright © 2003. All rights reserved. Adobe, the Adobe logo, PostScript, PostScript 3 and the PostScript logo are trademarks of Adobe Systems Incorporated. Microsoft, Windows, Windows NT, Windows Server are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. [. . . ] After the message is displayed, you can continue to print normally for about 100 sheets. Specify whether to stop printing when the drum/toner cartridge needs to be replaced. [Cancel Print] (default) Select this to stop printing after the message notifying that it is about time to replace the drum/toner cartridge was displayed and until it is replaced with a new one. [Continue Print] Select this not to stop printing even when the drum/toner cartridge needs replacing. Note that continuous printing after the replacement time has passed may affect the print image quality and the printer performance. It is recommended to install a new drum/toner cartridge. mm/inch Specifies the unit that is used on the control panel from [Millimeter (mm)] and [Inch (")]. This default setting varies depending on the countries. 76 4 Settings on the Control Panel Printer Settings [Printer Settings] menu is used to make settings for paper trays such as the auto tray selection feature. Substitute Tray Specifies whether to print on paper loaded in another tray when there is no paper left in the tray selected by the auto tray selection feature. If you want to replace paper, specify the paper size. [Off] (default) Select this not to replace paper but display a message prompting you to load paper. [Larger Size] Select this to replace the paper with a larger size paper before printing in 100% magnification ratio. [Nearest Size] Select this to replace the paper with the nearest size paper before printing. [Auto] (default) Select this mode when you want to use our PostScript driver. Selecting this will print on the paper loaded in the tray specified by the printer driver. [Select from tray] Some applications create the PostScript program directly without using a printer driver. In this case, a paper tray may not be selected correctly depending on the application. Selecting [Select from tray] ensures that data is printed on the specified paper. 78 4 Settings on the Control Panel Print Unused Form Specifies whether to cancel the job or to print data only if the form specified for printing is not registered. The default is [On (Data only)]. Default Paper Size Specifies the default setting of the paper size when using E-mail printing feature, the paper size when printing the reports, and the [Output Size] setting of the each print mode to [A4] or [8. 5×11"]. This default setting varies depending on the country where the printer is sold. Allocate Memory*3 (refer to P. 83) [Allocate Memory] menu is used to change the capacity of the memory for each interface and the form memory. In this printer, you can change the following memory allocation. · PS Memory · HPGL auto layout memory · Receive buffer memory · Print page buffer Important · Changing the memory capacity will reset the memory and delete all data stored in each memory area. · You cannot exceed the overall memory capacity during memory allocation. [. . . ] It can be used to describe incorporating software such as printer driver into the computer system as well as incorporating the network extension card into the printer. In this manual, "install" is mainly used to describe incorporating software into the computer. Interface The part that connects different systems (series). It is often used when describing the connection between computer and printer as well as between human and machine. In interface specifications, especially electrical specifications, it is also simply known as interface. Interface cable Cable for mutually connecting multiple machines together. [. . . ]