User manual KYOSHO OXALYS 50

[. . . ] If it is too high, you may damage the film. B < S OE You can keep the covering film from wrinkling or peeling by spraying the plane with clear polyurethane. Secure nylon hinges with instant glue, being careful not to glue the wing and aileron together. [. . . ] B " " , ð Temporarily install the engine and make a hole for the throttle rod by aligning with the position of the throttle lever. T Refer to the pictures below and install each servo. B , ð Position servos in neutral before commencing this step. B < Slide heat shrink tubes over linkage rods and use a shrink covering heat gun or similar to secure (shrink) them in place. B S , ð File down with the hole on an angle so the rods move smoothly. B , Make certain parts are aligned accurately and play is reduced to a minimum. For the correct placement of decals, please refer to box top. B , Í , Å Adjust the travel of each control surface to the values in the diagrams. B , É In order to obtain the CG specified, reposition the receiver and other equipment. B ` , Do not fly before confirming the correct location of the CG. If the CG is incorrect, you lose control of your airplane which leads to accidents!Beginners cannot fly and building this aircraft. *This aircraft has been flight tested with snap-rolls and other aerobatic maneuvers. However, repeated violent maneuvers may overstress the airframe. Please fly in a way that will not overstress the airframe. *Repeated flying can cause stress cracks to appear in the wood and joints. [. . . ] B By moving the throttle control stick, ensure the carburetor opens and closes without effort. B OEð If the dry batteries in the radio are flat, replace them with fresh ones. B " For starting the engine, apply low throttle and hold the engine starter against the spinner. [. . . ]