User manual KYOSHO PITTS SPECIAL 40 PARTS LIST

[. . . ] Mention of software products manufactured by other companies does not necessarily constitute endorsement by the manufacturer . While all reasonable efforts have been made to make this document as accurate and helpful as possible, we make no warranty of any kind, expressed or implied, as to the accuracy or completeness of the information contained herein. The most up-to-date drivers and manuals are available from the web site: http://www. okiprintingsolutions. com Trademark Information _______________________________ Oki and Microline are registered trademarks of Oki Electric Industry Company Ltd. Apple, Macintosh and Mac OS are registered trademarks of Apple Computers Inc. [. . . ] Select 17. 1 cpi [the default] or 20 cpi. FF Function Applies to the manual feed from the platform. Sets what happens when the printer receives the FF command. Eject [the default] or Form Feed. Form Tear-Off The default is Off. To activate Form Tear-Off, change the setting to On. The Forms Tear-Off feature allows a printed continuous form page to be torn off without wasting paper or adjusting the printer. For more information, see page 75. Front Load Adj. For fine tuning the Top of Form (TOF) location when using continuous forms (front feed). Settable from -40 to +40 in increments of 1/144 inch. The default is 0. Microline 8810 User's Guide 55 Negative values decrease the space down from the top of the form: · TOF moves up · paper moves down. Positive numbers increase the space down from the top of the form: · TOF moves down · paper moves up. Microline 8810 User's Guide 56 Gap Control Sets whether the printhead gap is set automatically [the default] or manually. Manual Gap Settings Setting Manual Gap 1 Used for · Single sheets 14 to 22 lb. US Bond (52 to 81 g/m2) · Thickness range 0. 06 to 0. 10 mm · Single sheets 22 to 34 lb. US Bond (81 to 128 g/m2) · 2-Part Multi-Part Forms (carbon-backed) · Thickness range0. 10 to 0. 15 mm · Single sheets 34 to 42 lb. Choose the printing used by the parallel interface: Uni-directional or Bi-directional [the default]. Parity Applies only when the optional RS-232C Serial Interface is installed. Settings include None [the default], Odd and Even. Path Change Choose whether or not the Tear Off feature is engaged when you change to the continuous forms path. To set the printer to automatically engage the Form Tear feature when it switches to continuous forms printing, change the setting to Tear Off. Microline 8810 User's Guide 61 PE Adj. [Paper End Adjust] For fine tuning the location of the last line of printing (Paper End) for a specific paper feed path. See below for a list of paper feed paths. Settable from -15 to +15 in increments of 1/144-inch. Negative values allow printing further down on the form. · Paper End moves down · paper moves up. Positive values stop the printing further up on the form. · Paper End moves up · paper moves down Paper Feed Paths · PE Adj. (Cut) Applies to sheets fed manually through the platform. · PE Adj. (CSFF) Applies to sheets fed through the optional CSF mounted on the front of the printer. · PE Adj. (CSFR) Applies to sheets fed through the optional CSF mounted on the rear of the printer. · PE Adj. (Front) Applies to continuous forms fed through the front tractor. · PE Adj. [. . . ] See the online Network User's Guide for details on how to use this utility. See "Network Setup Utility" on page 111. PrintSuperVision PrintSuperVision is a web-based application for managing printing devices connected to a network. PrintSuperVision provides access to networked printer data for monitoring, reporting and managing networked printers. [. . . ]