User manual KYOSHO RC SURFER

[. . . ] If you find any defective or missing parts, contact your local dealer or our Kyosho Distributor. Must be purchsed separately with other sets. B " , µ This kit contains many screws in and other hardware different metric sizes and shapes. B Self-tapping (TP) screws cut threads into the parts when being tightened. [. . . ] B For accident prevention, do not run your model under the following circumstances: Do not operate in heavy seas or when a storm warning is in force. With R/C boats, discover a new world of pleasure. Wheth- r you run your boat on lakes, rivers or elsee where, take precautionary measures to avoid accidents. B Do not put your hands or any objects into rotating parts, as this could result in serious accidents!B The motor and Ni-Cd battery get hot from run-ning. Do not touch them for a while after running. Notify the lifeguard of your presence, and follow his/her instructions. Always be considerate of other beach users whilst using this model. , µ , « , ê , « When rivers are swollen or their current is strong!B , ª , « Also make sure that nobody is using the same frequency as you do at the same time!B Never put the charger and Ni-Cd battery near flam-mable material while charging as this may cause fires!B OE¯ Under the following circumstances, short circuits may oc- ur and result in fires or other accidents: c · B Never dispose of Ni-Cd batteries into a fire, as these can explode or emit noxious gases from heavy met- ls a used in Ni-Cd batteries !When NOT using the model, always switch off the receiver and transmitter!Does the rudder operate according to your inputs on the transmitter?Does the speed controller operate according to your inputs on the transmitter?Is nobody on your frequency when running at the same time in the same area?Can all moving parts move freely, without binding?B Ensure that the speed control servo is in off position. B Make sure the rudder operates according to your inputs on the transmitter. B Make sure the speed controller operates according to your inputs on the transmitter. B Z After finishing running, collect your boat. B , â ' Avoid getting sand or water onto board interior whilst changing batterys. [. . . ] B < Make sure screws and nuts are securely tightened and other parts are not worn. Repair the wiring should cords be damaged or drag into rotating parts. Should servo cords and the receiver antenna be damaged, return them to the manufacturer for repair. Make sure all parts are neither worn nor damaged. [. . . ]