User manual KYOSHO SPITFIRE 50 EP

[. . . ] · Warnings and Important Safety Instructions in this manual do not cover all possible conditions and situations that may occur. It is your responsibility to use common sense, caution, and care when installing, maintaining, and operating your appliance. · Because these following operating instructions cover various models, the characteristics of your refrigerator may differ slightly from those described in this manual and not all warning signs may be applicable. If you have any questions or concerns, contact your nearest service center or find help and information online at www. [. . . ] You may find these items sold as a kit at your local hardware store. · · 6. 35mm compression nut plastic tubing · · copper tubing ferrule 01 SETTING UP Refrigerator Checktheaccessorylistbelow. Plastic tubing (A) (Supplied) Compression nut (A) (1/4") (Supplied) Compression fitting (Supplied) Ferrule (Not supplied) Molded end(bulb) Compression nut (b) (1/4") (Not supplied) Plastic tubing (b) (Not supplied) Hex wrench Fastener Copper tubing (Not supplied) or Household water line Compression fitting Compression nut Connectingtothewatersupplyline 1. First, shut off the main water supply line and turn the ice-maker off. Locate the nearest cold water drinking line. After connecting the water supply with water filter, turn on water supply and Flush 3L through filter before use (flush approximately 6 minutes). ColdWaterLine Pipeclamp Waterline installation kit Shutoffvalve 1. Slip the compression nut through the supplied plastic tubing(A). Tighten the compression nut (A) onto the 6. 35mm compression fitting. - If you are using copper tubing, slip the compression nut (B)(not included) and ferrule (not included) on copper tubing (not included) as shown. - If you are using plastic tubing (B), insert the molded end(Bulb) of the plastic tubing (B)into the compression fitting. Do not use without the molded end(Bulb) of the plastic tubing (B). Tighten the compression nut (B)onto the compression fitting. Do not over-tighten the compression nut (B). Remember to turn it off when you don't need it and return the freezer to your original temperature setting. If you need to freeze large amount of food stuff, set the temperature of freezer compartment as the coldest temperature before you turn on the Power Freeze Button. (2) Power Freeze (4) Lighting Pressing the Lighting button turns on the Dispenser LED lamp (under the display) in continuous mode so that it stays on continuously. If you want the Dispenser lamp to come on only when some one uses the dispenser, press the Lighting button to turn the continuous mode off. 12_ operating (5) Power Cool The Power Cool function substantially speeds up the refrigerator compressor, causing the refrigerator to cool down rapidly to a temperature you choose. When you press the Power Cool button, the Power Cool icon lights up. Power Cool is useful if you need to quickly cool items or need to cool the refrigerator rapidly if it has warmed dramatically (for example, if the door was left open). To turn off Power Cool, press the Power Cool button again. Power Cool turns off automatically after 2 1/2 hours to decrease energy consumption. When you turn on Power Cool, the refrigerator's compressor speeds up and is louder than during normal operation. If you don't want to make more ice, press the Ice Off button. Pressing this button 3 second locks the display panel and dispenser buttons so the buttons can not be used. The Child Lock icon lights up to indicate you've activated the Child Lock function. Press the Cubed Ice or Crushed Ice button to select the type of ice you want dispensed. Each time you press the button, the cubed and crushed ice modes alternate and the Cubed or Crushed ice icon lights up, indicating your selection. [. . . ] Did you wait for 12 hours after installation of the water supply line before making ice?Is the water line connected and the shut-off valve opened?Did you manually stop the ice making function?Try setting the freezer temperature lower. [. . . ]