User manual KYOSHO TF5 READYSET EXPLODED VIEW

[. . . ] Examples of these boxes and the type of information provided in each, are below. WARNING: PROVIDES INFORMATION THAT, IF UNHEEDED, MAY RESULT IN PERSONAL INJURY. CAUTION: PROVIDES INFORMATION THAT, IF UNHEEDED, MAY RESULT IN EQUIPMENT DAMAGE. ATTENTION: Provides information that is deemed of special importance but will not result in personal injury or product damage if unheeded. NOTE: Provides helpful hints to assist in performing the tasks at hand. LCD DISPLAY: Provides the specific display that should be visible on the LCD at that point. A comprehensive Table Of Contents provided at the front of this manual facilitates rapid movement within. The contents identify the different Units, Chapters, and some Sections. Each references the page number of their commencement. The pages of this manual have embedded headers and footers to assist the user in identifying his or her exact position within the manual. [. . . ] This memory can only be cleared through the printer's display. GL408-412e Operator Manual 4-51 PN: 9001163A Unit 4: Printer Configuration UNIVERSAL SERIAL BUS (USB) INTERFACE MODE (TABLE 4-7) MENU DESCRIPTION Communication Protocol. Selects the mode of Bi-Directional communications. In most cases this menu does not need to be altered and is meant to help support legacy applications which may have incorporated older bi-directional statuses. Anything other than Staus 5 or Standard (none) is not recommended. Comm. Protocol Status 5* · Status 5 - factory default. This status is the most recent and represented in the interface specifications. For more information, refer to the appropriate section in the programming and interface guide. · Standard - bi-directional interface is not used. · Status 2 - legacy bi-directional support. · Status 3 - legacy bi-directional support. · Status 4 - legacy bi-directional support. · Cancel - errors when the incorrect BCC is being accessed. When the printer is brought back online from an error, by pressing the Line key, the incorrect job is printed. · Resume - errors when the incorrect item number is being accessed. When the printer is brought back online from the error, by pressing the Line key, the incorrect job is canceled. The history buffer stores a history of printer statuses. Is only available when Status 5 is selected for Bi-Com interface. History Buffer Temporary* · Temporary - factory default. Store the history buffer in the internal RAM. This memory is deleted when the printer's power is turned off. · Permanent - stores the history buffer in Flash (internal or optional) Memory. This memory can only be cleared through the printer's display. GL408-412e Operator Manual 4-53 PN: 9001163A Unit 4: Printer Configuration LOCAL AREA NETWORK (LAN) INTERFACE MODE (TABLE 4-8) MENU DESCRIPTION Communication Protocol. Selects the mode of Bi-Directional communications. [. . . ] Refer to the Print Head Pressure chapter of this manual for instructions. NOTE: If a desired setting cannot be achieved through the dial alone, loosen the set set screw, adjust the plate, retighten the set screw, and then readjust the dial. BALANCE ADJUSTMENT Paper Width (millimeters) Dial Setting 25 to 55 1 2 55 to 85 3 4 80 to 110 5 Upper Print Assy Balance Dial Set Screw Dial Window Figure 6-5, Print Head Balance Adjustment GL408-412e Operator Manual 6-7 PN: 9001163A Unit 6: Maintenance PRINT HEAD PRESSURE Print Head Pressure allows for the print head to be adjusted to accommodate different media types (thicknesses). The pressure setting lever is two posiiton (normal and high). The table that follows coorelates the media media used with apressure setting. To adjust the pressure lever, the balance dial must be set to the "A" position. [. . . ]