User manual KYOSHO TWIN FORCE

[. . . ] The other operates on a 100V house outlet. B ^Ó, µ --, For painting the body, use Kyosho paints for models!B CAUTION: Before using spray colors, always read their explanations!B N For safe masking jobs, use this plastic masking sheet featuring one self-adhesive edge. [. . . ] L Refer to the pictures on the box for the color scheme. B "à Paint the body shell from the inside using Kyosho's spray colors. [ After painting, remove the protective film from the body shell. B The decal numbers between brackets are only for the opposite side. B Zæ , µ Slightly bend the body pins as shown in the diagram for easier removal. B Always run your car with the body shell fitted!Avoid changing the running direction too often and too abruptly. Do not run your car on ground: · B , ª S , ß The motor life for this 14. Therefore we recommended upgrading the motors if you find that speeds are too slow or the batteries lose power too quickly. B OE¯ Make certain that both batteries are fully charged. Otherwise performance may drop or overheating could result. If the slipper clutch slips too much and the car does not start off, tighten the 4mm nylon nut. B , µ `¬ , « , Á `¬ * As a thumb rule, set the slipper clutch to slip a little from a dead stop. B * The more the slipper clutch slip, the more heat is generated. The longer you run under such circumstances, the more likely you will damage the spur gear. B , , * Do not operate without a slipper clutch. B , , ^ Note the following in order to ensure smooth operation and long life of the 3-Speed Transmission. lubricate the ball bearings to ensure smooth operation. [. . . ] After operation, the electric motor and battery are hot!You may burn yourself seriously touching them!Batteries use heavy metals that are noxious to health!NEVER throw them into fires as they will explode! [. . . ]