User manual LA CROSS TECHNOLOGY TX21U

[. . . ] An outdoor wall or window can have up to 30 feet of resistance and an interior wall can have up to 20 feet of resistance. Your distance plus resistance should not exceed 330 ft. · The remote temperature/humidity sensor transmits a signal every minute. After the batteries have been installed, the indoor weather station will search for the signal for a duration of 15 minutes. [. . . ] 5) Insert the remote temperature/humidity sensor into the bracket. MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2) Remove the protective strip from one side of the tape. 3) Adhere the tape to the designated area on the back of the mounting bracket. 4) Remove the protective strip from the other side of the tape. 5) Position the remote temperature/humidity sensor in the desired location, ensuring that the indoor weather station can receive the signal. MOUNTING WITH NYLON STRAPS 1) Remove the mounting bracket from the remote temperature/humidity sensor. 2) Place two nylon straps through the slots on the mounting bracket. 3) Place the remote temperature/humidity sensor in your desired mounting location. 4) Fasten the two nylon straps securely around the mounting location. MAINTENANCE AND CARE INSTRUCTIONS · Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. · Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. · Immediately remove all low powered batteries to avoid leakage and damage. · Opening the casings invalidates the warranty. Contact La Crosse Technology for repairs. 3 WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. [. . . ] La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 e-mail: support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com FCC DISCLAIMER This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. FCC ID: OMO-01TX (transmitter) La Crosse Technology Made in China TX21U All rights reserved. [. . . ]