User manual LA CROSS TECHNOLOGY WS-7394U-IT

[. . . ] FCC ID: OMOTX29U (transmitter) RF Exposure mobile: The internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 21: Modifications not expressly approved by this company could void the user's authority to operate the equipment. 105: NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. [. . . ] Press and release the "SET" button ten more times to advance to the Temperature Measuring Units setting. Press and release the "SET" button to confirm the temperaturemeasuring unit and continue to the Air Pressure Measuring Units setting. Press and release the "SET" button twelve more times to advance to the Relative Pressure setting. The barometric air pressure will flash in the middle of the display, just below the forecast icon 5. Press and release the "OUT/+" or "IN" button to select the desired relative air pressure value. Press and release the "SET" button to confirm the relative pressure setting and continue to the Forecast Sensitivity setting. "lcd" will appear at the top of the display and a number will flash next to it. Press and release the "SET" button eleven more times to advance to the Air Pressure Measuring Units setting. Press and release the "SET" button to confirm the air pressuremeasuring unit and continue to the Relative Pressure setting. "lcd" will appear at the top of the display and a number will flash next to it. "lcd" will appear at the top of the display and a number will flash next to it. following the indoor temperature and humidity , and the time as 12:00 will be displayed. If they are not shown in LCD after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. The outdoor temperature from the first sensor (channel 1) should then be displayed on the Weather Station. If this does not happen and the signal reception icon is not shown, after 2 minutes, the batteries will need to be removed from both units and reset from step 1. Insert the batteries to the second sensor as soon as the outdoor temperature readings from the first sensor are displayed on the Weather Station. The minimum and maximum values are updated automatically when a new minimum or maximum is recorded, or until manually reset. From the normal display mode, press and release the "IN" key once to view the indoor maximum temperature and humidity ("MAX" will be displayed above the indoor temperature and humidity). Press and release the "IN" key again to view the indoor minimum temperature and humidity. Press and release the "IN" key again to return to the normal mode (timeout of viewing minimum/maximum values will occur if no keys are pressed for fifteen seconds). Note: To reset the indoor minimum and maximum temperature and humidity, first display the values you wish to reset (minimum or maximum). Next press and hold the "SET" key for at least three seconds. [. . . ] The first reception is most difficult, as the indoor weather station needs five continual minutes of clear signal reception. After the initial time/date set, the indoor weather station only requires one full minute of clear reception each night. La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. [. . . ]