User manual LA CROSS TECHNOLOGY WS-9031U QUICK START GUIDE

[. . . ] WS-9031U Quick Set-up instructions 1) 2) Insert two AA batteries into the remote transmitter. Insert three AA batteries into the Weather Projection Station and/or plug into wall. Note: When starting or restarting your weather projection station the transmitter should be started first and then your weather projection station. After power is supplied (either battery or AC) ensure that no buttons are pressed for 15 minutes. [. . . ] The range runs from 0 to -12 and then runs from +12 back to 0 in consecutive 1-hour intervals. time zone map available for ­5hr(EST), 6hr(CST), -7hr(MST) and ­8hr(PST) zones. Confirm with the SET key and enter the DST (Daylight Saving Time) setting. DST (DAYLIGHT SAVING TIME) SETTING: Flashing Note: The DST default is "ON", meaning that the received time will automatically be adjusted according to Daylight Saving Time in the spring and fall. For areas that do not recognize DST changes (Arizona and parts of Indiana) turn the DST "OFF". The digit "ON" will start flashing on the LCD. Use the CH/+ key to turn OFF the DST function. Confirm with the SET key and enter the Time Reception ON/OFF setting. TIME RECEPTION ON/OFF SETTING: Digits flashing In area where reception of the WWVB time is not possible, the WWVB time reception function can be turn OFF. The clock will then work as a normal Quartz clock. The digit "ON" will start flashing on the LCD. Use the CH/+ key to turn OFF the time reception function. Confirm with the SET key and enter the 12/24-HOUR setting. Note: If the Time Reception function is turned OFF manually, the clock will not attempt any reception of the WWVB time as long as the Time Reception OFF function is activated. The Time Reception and the "WWVB" icons will not be displayed on the LCD. 12/24-HOUR SETTING: Flashing The hour display can be selected to show hours in 12-hour or 24-hour settings. Use the CH/+ key to toggle between "12H" or "24H". Confirm with the SET key and enter the Manual time setting. MANUAL TIME SETTING: In case the Weather Projection Station cannot detect the WWVB-signal (for example due to disturbances, transmitting distance, etc. ), the time can be manually set. The clock will then work as a normal Quartz clock. Hour flashing Minutes flashing The hour digit will start flashing. Press again the SET key to set the minutes. Confirm with the SET key and enter the Calendar setting. 1. 5. Note: The unit will still try to receive the signal between 12:00 to 6:00 a. m. every day despite it being manually set and if the WWVB time reception function has been set ON. When it does receive the signal, it will change the manually set time into the received time. [. . . ] La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. [. . . ]