User manual LA CROSS TECHNOLOGY WT-2100

[. . . ] Should after 10 minutes and the time is still not received the clock will automatically attempt to receive the WWVB time signal two hours later. Manually set the time (see "Manual Time Setting" below). inserting the battery) DO NOT press any of the keys as this will interrupt stop the WWVB time signal reception. If keys are pressed during this stage, then proceed from "Setting up the Atomic Alarm" above. [. . . ] Automatic switching of summer/winter time will be enable if DST is ON. Now press the SET" key to enter the "Snooze setting" mode. Snooze setting mode (default setting10 minutes): 1. Use the "MODE/+" key to select the desired snooze interval from 0-59 minutes (snooze function will disable if the minutes are set to "00") 2. Now press the "SET" key to enter the "Time setting" mode. Time setting mode: In some cases, the Alarm Clock may not be able to detect the WWVB signal which means the WWVB tower icon will not show at all on the LCD (see Trouble Shooting) because it is only visible when the signal is present. To overcome this problem, the time can be manually set for the time being (see Manual Time Setting below) by entering the setting mode. Following on from the Snooze setting mode, the hour digits will start flashing in the manual time setting mode. Use the "MODE/+" key to set the desired hours followed by pressing the "SET" key to move to the minutes setting 2. The minute digits will now start flashing. Set the desired minutes by pressing the "MODE/+" key followed by pressing the "SET" key to move to the "Year Setting" mode Year setting mode: 1. In the calendar section the year digits will start flashing (default setting year 1999). Select the desired year (from 1999 to 2019) by using the "MODE/+" key. Press the "SET" key to switch to the "Month setting" mode. The month digits will start flashing (default setting month is 1). Set the desired month by using the "MODE/+" key. Press the "SET" key to move to the "Day setting" mode. The digits for the date will start flashing (Default setting 1). Set the desired date by using the "MODE/+" key. Press the "SET" key to enter the "Weekday setting" mode. The weekday will start flashing (Default setting MON). Set the desired weekday by using the "MODE/+" key. [. . . ] However if reception has been unsuccessful, the WWVB tower icon will not appear and reception will be attempted the following hour up to 6:00 a. m. Care and Maintenance: · · · · · · Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and could give inaccurate readings. When cleaning the display and casing, use a soft cloth only. Do not use solvents or scouring agents as they may mark the LCD and casing. Immediately remove any low powered battery to avoid leakage and damage and replace only with a new battery of the recommended size. [. . . ]