User manual LA CROSS TECHNOLOGY WT-9300

[. . . ] The time zones are abbreviated with three letters as follows: Eastern Central Mountain Pacific EST CST MST PST ABOUT RADIO-CONTROLLED TIME - WWVB The NIST (National Institute of Standards and Technology-Time and Frequency Division) WWVB radio station is located in Ft. Collins, Colorado, and transmits the exact time and date signal continuously throughout the United States at 60 kHz. The signal can be received up to 2, 000 miles away through the internal antenna in the alarm clock. Due to the nature of the Earth's Ionosphere, reception is very limited during daylight hours. [. . . ] · "DST" will be displayed to the left of the time zone abbreviation. · Press and release the "MODE/MIN" button to toggle between daylight saving time on and off. · Press and release the "Snooze" button twice to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Display Mode Setting The display below the time can be switched between showing the seconds and the alarm time. To switch between these two modes press and release the "MODE/ MIN" button. Setting the Alarm To set the alarm press and hold the "AL/HR" button for three seconds. · The alarm time will flash in the bottom left of the LCD screen. · Press and release the "AL/HR" button to advance to the desired hour. · Press and release the "MODE/MIN" button to advance to the desired minute. · Press and release the "Snooze" button to return to the normal display mode or wait 20 seconds and the travel alarm will time out and automatically return to the normal display mode. Operating the Alarm and Snooze To turn the alarm on press and release the "AL/HR" button. The alarm icon will be displayed in the lower right of the LCD to indicate that the alarm has been turned on. The alarm will sound for 100 seconds once activated. By pressing the snooze button the alarm will be suspended for 8 minutes. take up to 72 hours before a good signal is received. The reception can be helped by placing the clock in a window facing Colorado, with the back towards Colorado. MAINTENANCE AND CARE INSTRUCTIONS · Extreme temperatures, vibration, and shock should be avoided to prevent damage to the unit. · Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. · Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. · Opening the casings invalidates the warranty. Contact La Crosse Technology repairs. TROUBLESHOOTING NOTE: For problems not solved, please contact La Crosse Technology via e-mail or phone, or visit our website, www. lacrossetechnology. com Problem: The time and date will not set initially. Solution: It usually takes overnight before the clock can receive the signal due to the interference the sun has on the WWVB signal. Solution: Computer monitors and televisions can cause interference with the signal reception. Please keep the clock at least six feet from electrical sources. [. . . ] You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: La Crosse Technology, Ltd 2809 Losey Blvd S. La Crosse, WI 54601 Phone: 608. 782. 1610 Fax: 608. 796. 1020 e-mail: support@lacrossetechnology. com (warranty work) sales@lacrossetechnology. com (information on other products) web: www. lacrossetechnology. com All rights reserved. [. . . ]