User manual LA CROSS TECHNOLOGY WT-961A

[. . . ] The default (factory) setting is Daylight Saving Time On and 12-hour Time mode. Press and hold the TIME ZONE button for 4 seconds "DST ON" and "12h" will be displayed in the time LCD. Press and release the TIME ZONE button to select the desired mode. The four selections are: DST On, 12-h DST Off, 12-h DST On, 24-h DST Off, 24-h 5. [. . . ] Clean the watch with a soft dry cloth, or with one moistened with a mild soap solution. Do not use any chemical cleaning solutions, these may cause permanent damage to the watch's surface. While the watch is water resistant to 100 feet, do not submerge in water for extended periods of time. I. The default time zone is Eastern Time (EST, also GMT-5). The selection will cycle from GMT-5 (EST) to GMT-12, then GMT+12 to GMT +1, then GMT, then GMT-1 to GMT ­5 (EST). Hold down the TIME ZONE button for 2 seconds or until a time zone abbreviation and "ZONE" flash in the LCD. Repeatedly press and release the TIME ZONE button until the appropriate Time Zone is displayed. Wait 8 seconds for the automatic time-out to exit the time zone selection mode. "Hawaii Time displayed (GMT-10) VI. ADJUSTING THE STRAP The metal/plastic strap is adjustable to fit most all wrist sizes. You may either take it to a local jeweler for adjustment, or perform the following steps. The strap is adjusted by removing/adding equal number of links on either side of the butterfly strap (or either side). The links are held in place by a small pin. Use a small tool (a paperclip also works) to press out the pin(s) in the direction of the arrow on the link. Remove the pin on the other side of the link to remove the link. Press the pin back in place in the direction of the arrow. Repeat as necessary. Atlantic Time (ATL): Eastern Time (EST): Central Time (CST): Mountain Time (MST): Pacific Time (PST): GMT-4 GMT-5 GMT-6 GMT-7 GMT-8 Alaska Time (ALA): GMT-9 Hawaii Time (HAW): GMT-10 Greenwich Mean Time (GMT): GMT VII. REPLACING THE BATTERY The battery can either be replaced by a qualified jeweler or watch repair shop, or by the user. Any damage resulting from this procedure is not covered under warranty. Remove the four screws located on the back and remove the cover. Be sure the watch movement and gasket do not come out of the case. Remove the old battery by gently prying up the battery clip. Insert a new battery of the type "CR1620" 3 Volt Lithium Cell battery Please dispose of the old battery properly. WARRANTY INFORMATION La Crosse Technology provides a 1-year warranty on this watch. Contact La Crosse Technology immediately upon discovery of any defects covered by this warranty. Before sending the watch in for repairs, contact La Crosse Technology. [. . . ] 3) To help with overnight reception, place watch in a window with the band inline with the general direction of Ft. 4) There are a few places the signal is very weak (Los Angeles area, Some parts of Florida and New York City). Since the watch has a much smaller receiver than our other clocks, it is possible no reception can be made. Please inform La Crosse Technology in this case. [. . . ]