User manual LA CROSSE TECHNOLOGY 306-605

[. . . ] Pull off the protection foil on the display Attach the thermometer holder to the outside of the window with the enclosed adhesive tape. (Be sure to mount with the frame "bar" down. ) Check that the bottom bar is in place to "catch" the thermometer, then hang the thermometer on the holder by sliding it down into the holder. Note: The thermometer is fragile. When you mount or remove the thermometer, avoid action that would bend or pull on it. Fig. Temperature Probe Battery Compartment Solar Panel SETUP INSTRUCTIONS Remove the thermometer holder from the thermometer by sliding it towards the bottom of the thermometer. [. . . ] If there is no confirmation within 15 seconds, the DST symbol will stop flashing and will disappear. If this has happened and you need to put your thermometer into DST mode, see the section on Daylight Savings Time later in this manual. CHANGE BETWEEN DAYLIGHT SAVINGS TIME / STANDARD TIME Press the +/-1hr (underneath the top part of the thermometer to enable/disable DST mode. Note: When the display is in DST mode, the DST indicator is shown (see Fig. 1, D). Backlight To set the backlight mode, find the ECO slide switch underneath the top section of the thermometer (see Fig. The display will automatically turn on the backlight for night viewing. The backlight can be set to one of two modes: Full Power: When the ECO switch is OFF, the backlight comes on at dark and turns off at dawn), as soon as the solar panel no longer detects light (with appropriate battery charge). ECO MODE ­ When the ECO switch is ON, the backlight turns on at dark, but only between 5:00PM and 9:00PM. . Note: The left NiMh battery (when holding the thermometer with the display at the bottom) is the illumination battery The right non-rechargeable alkaline battery provides powers all other functions. SET THE CLOCK Press the MODE button and the hour digits in the upper display start flashing. Press the +1 button to adjust the hour value. Press the +1 button to adjust the minutes value. Press the MODE button to confirm. TEMPERATURE DISPLAY The middle display shows the current e. The lower display shows the history of minimum and maximum temperature. The black pin close to the +/-1hr button and ECO slide is the temperature probe. It has no adjustments, and should not be moved or twisted. Please take care not to break this probe. CHANGE THE DISPLAY There are two display modes for your thermometer. Press the +1 button to change between Mode 1 and Mode 2 or back. Mode 1: All temperatures are in Celsius, and the time mode is 24-hour time. Mode 2: All temperatures are in Fahrenheit, and the time mode is 12-hour (AM/PM) time. . IMPORTANT NOTICE Due to heat emission and the protected location of your window, it is possible for the temperature displayed to be higher than the outdoor temperature would be read at another nearby unsheltered location. MAX/MIN TEMPERATURES The Max temperature is updated each day at 8:00AM, and the Min temp is updated each day at 8:00PM. 5 6 SPECIFICATIONS Measuring Range: Batteries: -13F to +158F (-24C to +70C) 1 x 1. 2V AAA NiMh Rechargeable Battery (included) 1 x 1. 5V AAA Non-rechargeable Alkaline Battery (included) WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. [. . . ] THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. [. . . ]