User manual LA CROSSE TECHNOLOGY 616-146

[. . . ] Note: In the event of changing batteries in any of the units, all units need to be reset by following the setting up procedures. This is due to a random security Replace compartment cover. BATTERY CHANGE: It is recommended to replace the batteries in all units on an annual basis to ensure optimum accuracy of these units. Please participate in the preservation of the environment. Return used batteries to an authorized depot. 3 4 SET UP 1. [. . . ] Confirm with the SET key and enter the "Manual time setting". Note: When 12h mode display is selected, the calendar format will be "Month. When 24h mode display is selected, the calendar format will be "Day. Month" display. Outdoor data signal reception indicator* Low battery indicator (transmitter) * When the signal is successfully received by the weather station, the outdoor transmission icon 7 8 MANUAL TIME SETTING: To set the time. 3. 4. 5. Hour flashing Minutes flashing 6. Press again the SET key to set the minutes. Confirm with the SET key and enter the Calendar setting. 7. Press the SET key again to confirm and to enter the month setting. Press the SET key again to confirm and to enter the date setting mode. Confirm all calendar settings with the SET key and "ºF/ºC temperature display setting". °F/°C TEMPERATURE UNIT SETTING flashing 5. CALENDAR SETTING: The date default of the weather station is 1. To set the calendar: Year The default temperature display is set to °F (degree Fahrenheit). The "°F or qC" will flash. Pull the stand out from the bottom center edge of the weather station, below the battery compartment. Once the foldout table stand is extended, place 13 14 the weather station in an appropriate location. CARE AND MAINTENANCE: x POSITIONING THE THERMO-HYGRO TRANSMITTER Before permanently fixing the thermo-hygro to the wall base, pace all units in the desired locations to check that the outdoor temperature and humidity readings are receivable. In event that the signal is not received, relocate the thermo-hygro transmitter or the weather station slightly as this may help the signal reception. x x x Mount in a sheltered place. Avoid direct rain and sunshine. The thermo-hygro transmitter can be placed onto any flat surface or wall mount using the bracket which doubles as a stand or wall mount base. x x Extreme temperatures, vibration and shock should be avoided as these may cause damage to the units and give inaccurate forecasts and readings. When cleaning the display and casings, use a soft damp cloth only. Do not use solvents or scouring agents as they may mark the LCD and casings. Immediately remove all low powered batteries to avoid leakage and damage. Replace only with new batteries of the recommended type. Do not make any repair attempts to the units. Return it to their original point of purchase for repair by a qualified engineer. Opening and tampering with the units may invalidate their guarantee. [. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: x Reorient or relocate the receiving antenna. [. . . ]