User manual LA CROSSE TECHNOLOGY C86371

[. . . ] See a small button called TX, push down on the this button for 3 seconds and this will send a signal to your LCD display. For optimal reception performance, of the 433 MHz signal, the outdoor transmitter should be placed within 200 feet (60 meters) from the Indoor LCD display. The Color LCD display weather Icons will require 6 -12 hours to initialize based on outdoor weather conditions so do not consider the immediate readings as accurate. Color Wireless Atomic Weather Station Model: C86371 INTRODUCTION: The Color Wireless Atomic Weather Station offers radio-controlled time, weather forecast, indoor and outdoor temperature, humidity, heat index and dew point, on a stylish, colorful, and easy to read display. [. . . ] bUTTON FUNCTIONS: Button SET ALARM +/RCC -/°C/°F MIN/MAX HEAT/DEW CH LIGHT HI/LO HOLD ON/OFF LIGHT/SNOOZE (top) Press and Release Functions Move through program menu Confirm setting. View Alarm Activate/Deactivate Alarm 1 step forward (setup) Select temperature in °C/° F 1 step backward (setup) 1-time MAX values 2-times MIN values 1-time Heat Index 2-times Dew Point Switch channels (multiple transmitters) Dim backlight for night time. Activates backlight when using only batteries. Trigger snooze alarm Hold 3-5 seconds Enter program menu, set time, date, etc. Alarm set Search for WWVB signal Fast advance (setup) Fast backward (set) Resets all MIN / MAX values Color LCD Battery Compartment 5 volt a/c Set up instructions step by step: Step 1: Remove battery cover from LCD Display, slide tab to right and pull out to remove the cover. Insert 3 NEW AA batteries (not included) into the back of the LCD Display. Observe the correct polarity (see marking inside the battery compartment). Do Not mix old and new batteries, use Alkaline batteries. The display will light up and display, indoor temperature, humidity and channel 1. Step 2: Insert the 5 volt AC power adapter into the designated area on the back of the LCD display. Insert the power adapter plug into a wall outlet if you want a continuous backlight display. IMPORTANT: When operating on a/c power, the backlight will turn off while the Display searches for the WWVB signal, to avoid interference. The backlight will return after the 2-10 minute search. Step 3: Install batteries into the outdoor transmitter. Slide the battery cover down and lift off the back of the transmitter Insert 2 NEW AA batteries into the transmitter. You will see a CH switch next to the battery install area, this is factory set at Channel 1, keep it at channel 1. Keep the LCD display and the transmitter close to each other (within 10 feet) Within 3 minutes the LCD display will Beep and the Outdoor temperature should be displayed. Trouble shooting: If after 3 minutes of waiting, the Outdoor temperature does not show up in the designated area on the display Remove the power adapter and all batteries from both units and TRY the set up again. If the outdoor temperature does not show up after a second attempt to initiate, we suggest you slide open the battery cover of the outdoor transmitter and you will Search for remote transmitter Turn continuous backlight ON or OFF (a/c adapter) BACKLIGHT: A/C adapter: The backlight is on continuously when operating the display with the 6-volt a/c adapter. hIGH: The backlight is defaulted to HI when the a/c cord is inserted. LO: Press and release the LIGHT HI/LO button to dim the backlight. Press and release again to return to full strength. [. . . ] View Dew Point: From a normal display press the HEAT/DEW button twice and Dew Point will show instead of the ambient temperature. WEATHER FORECAST ICONS: The unit predicts weather condition of the next 12-hours based on the change of atmospheric pressure. The weather forecast is based on atmospheric pressure change and is about 70-75% correct. As weather conditions cannot be 100% correctly forecasted we cannot be responsible for any loss caused by an incorrect forecast. [. . . ]