User manual LA CROSSE TECHNOLOGY TX21U INSTRUCTION MANUAL

[. . . ] TX15U Wind Speed Sensor The TX15U wind sensor is used in conjunction with the TX8U temperature/ humidity sensor to gather and transmit information to your wireless weather station. The TX15U wind sensor measures the wind speed and sends the information to the TX8U temperature/ humidity sensor. This sensor then transmits all outdoor weather information from both outdoor sensors to the display indoors. TX15U wind sensor Mounting bracket Mounting hardware Instruction manual and warranty card QUICK SET-UP GUIDE Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. [. . . ] 3) Through the two screw holes of the bracket, mark the mounting surface with a pencil. 4) Screw mounting bracket onto the mounting surface. Ensure that the screws are tight against the bracket. 5) Insert the remote temperature/humidity sensor into the bracket. MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2) Remove the protective strip from one side of the tape. 3) Adhere the tape to the designated area on the back of the mounting bracket. 4) Remove the protective strip from the other side of the tape. 5) Position the remote temperature/humidity sensor in the desired location, ensuring that the indoor weather station can receive the signal. MOUNTING WITH NYLON STRAPS 1) Remove the mounting bracket from the remote temperature/humidity sensor. 2) Place two nylon straps through the slots on the mounting bracket. 3) Place the remote temperature/humidity sensor in your desired mounting location. 4) Fasten the two nylon straps securely around the mounting location. II. · · THE REMOTE WIND SPEED SENSOR The remote wind speed sensor can be mounted two ways: With the use of screws Using nylon straps A. MOUNTING WITH SCREWS 1) Unlock the mounting bracket from the remote wind speed sensor leaving the wire going through the bracket. 2) Place the mounting bracket over the desired location. 3) Through the two screw holes of the bracket, mark the mounting surface with a pencil. 4) Screw the mounting bracket onto the mounting surface. Ensure that the screws are tight against the bracket. 5) Slide the remote wind speed sensor onto the bracket making sure to lock it in place. MOUNTING WITH NYLON STRAPS 1) Unlock the mounting bracket from the remote wind speed sensor leaving the wire going through the bracket. [. . . ] Under non-laboratory conditions, it is difficult to compensate for the above factors and obtain an accurate comparison. MAINTENANCE AND CARE INSTRUCTIONS · · · · · Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. Immediately remove all low powered batteries to avoid leakage and damage. [. . . ]