User manual LA CROSSE TECHNOLOGY TX6U

[. . . ] Place the batteries into the outdoor remote first then into the indoor station. (All outdoor remotes must be started before the indoor station) DO NOT PRESS ANY BUTTONS FOR 10 MINUTES. In this time the display and sensor will start to talk to each other and the display will show both the indoor temperature and an outdoor temperature. If the station does not display both temperatures after the 10 minutes please retry the set up as stated above. After both indoor and outdoor temperatures are displayed for 10 minutes you can place your sensor outdoors and set your time. [. . . ] 2) Place the mounting bracket over the desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. 3) Where marked, start the screw holes into mounting surface. 4) Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. MOUNTING WITH ADHESIVE TAPE 1) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2) Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket. 3) Remove the protective strip from the other side of the tape. Position the remote temperature sensor/transmitter in the desired location, ensuring that the weather station can receive the signal. Mounting Bracket SPECIFICATIONS Temperature measuring range: Outdoor: -21. 8°F to 157. 2°F with 0. 2°F resolution. (-29. 9°C to 69. 9°C resolution) "OFL" displayed if outside this range Outdoor temperature checking Every 1 minute interval (remote temperature sensor/transmitter): Transmission Range: 80 feet (in open space) Power Supply: Temperature sensor/transmitter: 2 x AA, IEC LR6, 1. 5V Battery life cycle: Approximately 12 months Recommended battery type: Alkaline Dimensions (L x W x H) Temperature sensor/transmitter: 1. 57" x 0. 9" x 5. 04" (40 x 23 x 128 mm) WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. [. . . ] This handbook may contain mistakes and printing errors. The information in this handbook is regularly checked and corrections made in the next issue. We accept no liability for technical mistakes or printing errors, or their consequences. All trademarks and patents are acknowledged. FCC ID: OMO-01TX THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. [. . . ]