User manual LA CROSSE TECHNOLOGY WS-2815U-IT

[. . . ] "1. 45 in" is displayed in the rain section. This is the rain multiplicator; each tip of the rain bucket represents 0. 0145 inches of rain. This can be adjusted, but it is not recommended. You may press the "Unit" key to switch between inches and millimeters for rain measurement. [. . . ] The indoor sensor should be mounted in a location where main indoor temperature measurement is desired. Keep away from sources of heat and cool. The transmission signal travels in a straight line from the sensor to the display/receiver. Any obstacles in this path may cause interference and limit the range. A typical wall will decrease the signal range about thirty feet (300 feet is the rated range in free space). Operating Tips 1. Minimum and maximum values are stored for all data (no minimum rain or wind). Press the "Min/Max" key once to view minimum values. Press the "Min/Max" key again to view maximum values. While viewing all minimum or maximum data, press the or keys to scroll through each value with the corresponding time and date of occurrence. To exit this mode, view all minimum or maximum values and press the "Min/Max" key to exit. Alarms can be set for all values (except rain). These are available through your retailer or by contacting La Crosse Technology directly. A total of nine temperature and humidity may be received; two are included. The indoor sensor included will always be displayed on the left side of the display. All other temperature and humidity sensors will be displayed on the right side, along with a number. "Addressing" an additional sensor will be necessary for it to be viewed as the desired number. The sensors that are included and most additional sensors are addressed from the factory and do not need addressing. WS2010-20 indoor temperature, humidity, and pressure sensor is included, and no more may be added. WS2010-25 outdoor temperature and humidity (solarpowered) is included, and may be ordered as an addition. WS2010-22 indoor temperature and humidity (battery operated) looks the same as the WS2010-20. This is not included and available as an addition. WS2010-28 weatherproof temperature probe (battery operated). [. . . ] Before sending the Weather Station in for repairs, contact La Crosse Technology. The Weather Station will be repaired or replaced with the same or similar model. This warranty does not cover any defects resulting from improper use, use other than home or office (i. e. on a boat) unauthorized repairs, faulty batteries, or the Weather Stations inability to receive a signal due to any source of interference. [. . . ]