User manual LA CROSSE TECHNOLOGY WS-6010U-IT

[. . . ] Then the transmitter enters STOP mode. Idle Operation Mode: This mode occurs when the battery voltage drops lower than 2. 4V. Does not perform temperature measurement and transmission. The environment brightness is checked every 5 seconds. If battery voltage is raised higher than 2. 5V, the unit will go into Normal mode. [. . . ] Always wait at least 10 minutes after removing batteries before re-inserting; otherwise start up problems may occur. 3. TO SET THE TIME Note: The time will be displayed with "AM" or "PM" for the time from 12:00 noon until 11:59. Press and hold the SET key for 3 seconds to enter the time setting mode. 6. The hour digits will start flashing. Set the desired hours by pressing and releasing the + key followed by pressing the SET key. Now the minute digits will start flashing. Set the desired minutes by pressing and releasing the + key. If the + key is held, the units will increase by 5. Press the SET key again to confirm and enter the Solar Mode setting. SOLAR MODE The Solar Mode is used for saving the power consumption of the rechargeable battery (Default setting ON): 1. The characters "ON" or "OFF" will start flashing. By use of the + key select "ON" or "OFF" to set the solar mode. Press and release the SET key to exit the setting mode and switch back to the normal display mode. If the solar mode setting is ON: The surrounding environment brightness is checked every 5 seconds. LCD will automatically turn OFF if the environment is too dark. LCD will automatically turn ON if the environment is bright enough. No information will be displayed when the LCD is OFF, but all the settings and operations will remain, except for the temperature and humidity measurements. If the solar mode setting is OFF: LCD will remain ON constantly. STOP MODE If the Solar Station is placed in a dark environment for 72 hours continually, the clock will go to the stop mode: The most power saving condition. 7 The Solar Station will not perform any operation and the LCD will also be OFF. Press any key to wake up the Solar Station and to re-activate the transmission with the solar transmitter. MIN/MAX: Press and release the PLUS button to view: Outdoor Temperature minimum and maximum. Indoor temperature minimum and maximum. RESET MIN/MAX: Press and hold the PLUS button for 10 seconds to reset the indoor and outdoor minimum and maximum temperatures to current temperatures. DISPLAY MODES: Press and release the SET button to view Shows outdoor temperature in the first line on the left side and outdoor humidity in the second line on the left side. Shows indoor temperature in the first line on the right side and indoor humidity in the second line on the right. Shows outdoor temperature in the first line on the left side and outdoor humidity in the first line on the right side. [. . . ] You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: 11 La Crosse Technology 2817 Losey Blvd. La Crosse, WI 54601 The complete instruction manual is available at: www. lacrossetechnology. com/support Le manuel d'instruction complet est disponible sur: www. lacrossetechnology. com / support El manual de instrucciones completo está disponible en: www. lacrossetechnology. com / support All rights reserved. [. . . ]