User manual LA CROSSE TECHNOLOGY WS-7013BZ

[. . . ] WS-7013U Wireless 433 MHz Temperature Station Instruction Manual 1 TABLE OF CONTENTS Topic Inventory of Contents Quick Setup Detailed Setup Guide Battery Installation Setting the Time Selecting Units of Measurement Features Minimum and Maximum Temperatures Resetting Minimum and Maximum Temperatures Additional remote temperature sensors (optional) Mounting Troubleshooting Maintenance and Care Specifications Warranty Information Page 3 4-8 9-10 11-12 12-13 13 14 14-17 17-18 19-21 21 22-23 24-27 2 INVENTORY OF CONTENTS 1. The indoor temperature station (Figure 1) 2. The remote temperature sensor (TX6U) and mounting bracket. One strip of double sided adhesive tape. [. . . ] Press and release the "SET" button twice to activate settings. IV. Press and release the "MIN/MAX" button, "MIN" appears in the temperature LCD's and the recorded minimum temperatures are displayed. Press and release the "MIN/MAX" button to toggle to the maximum temperatures. The time of occurrence of the value for outdoor temperature will also flash. 13 B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES 1. To reset both the minimum and maximum temperatures--press and hold the "RESET/+" button for 4 seconds. C. ADDING ADDITIONAL REMOTE TEMPERATURE SENSORS (OPTIONAL) 1. The WS-7013U is able to receive signals from 3 different remote temperature sensors. Following are some brief instructions for the basic set-up of remote temperature sensor units with the WS-7013U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6 will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the 14 TX3UP will monitor the temperature via a probe for use in pools, spas, etc. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensor units, and in numeric sequence. Second, install batteries into the indoor temperature station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. It is necessary to remove the batteries from all units currently in operation. Remove the battery covers to all remote temperature sensor units. Place all remote temperature sensor units in a numeric sequential order. In sequential order, install batteries (follow the same battery installation procedures seen in section "I" of the Detailed Set-Up Guide). 15 6. Install batteries into the indoor temperature station. 7. Follow the Detailed Set-Up Guide for programming and operating instructions. D. VIEWING AND OPERATING WITH MULTIPLE REMOTE TEMPERATURE SENSOR UNITS 1. To view the temperature of a different remote temperature sensor unit, press and release the "CH" button. [. . . ] Under non-laboratory conditions, it is difficult to compensate for the above factors and obtain an accurate comparison. MAINTENANCE AND CARE INSTRUCTIONS · Extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. 20 · · · · Clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. [. . . ]