User manual LA CROSSE TECHNOLOGY WS-7013TWC

[. . . ] Quick Start for your WS-7013U Hint: Use good quality Alkaline Batteries and avoid rechargeable batteries. Have the indoor station and outdoor remote 3 to 5 apart. Batteries should be out of both units for 10 minutes. Place the batteries into the outdoor remote first then into the indoor station. [. . . ] Press and hold the SET button for 1 second. "°F" will appear in the TIME LCD. Press the MIN/MAX button to shift between °F and °C. Press the SET button twice to activate settings. IV. "MIN" appears in the temperature LCD's and the recorded minimum temperatures are displayed. Press the MIN/MAX button to toggle to the maximum temperatures. The 6 time of occurrence of the value for outdoor temperature will also flash. B. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES 1. To reset both the minimum and maximum temperatures--press and hold the RESET/+ button for 4 seconds. C. ADDING ADDITIONAL REMOTE CONTROL SENDERS (OPTIONAL) 1. The WS-7013U is able to receive signals from 3 different Remote Control Senders. Following are some brief instructions for the basic set-up of Remote Control Sender units with the WS-7013U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX2U will monitor temperature only, a TX3U will monitor temperature and 7 display the temperature on its LCD, and the TX3UP will monitor the temperature via a probe for use in pools, spas, etc. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the Remote Control Sender units, and in numeric sequence. Second, install batteries into the Indoor Temperature Station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. It is necessary to remove the batteries from all units currently in operation. Remove the battery covers to all Remote Control Sender units. Place all Remote Control Sender units in a numeric sequential order. In sequential order, install batteries (follow the same battery installation 8 procedures seen in section I. Install batteries into the Indoor Temperature Station. [. . . ] Do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. Opening the casings invalidates the warranty. Contact La Crosse Technology repairs. · · · 14 SPECIFICATIONS Transmitting 433MHz Frequency Measuring Temperatures Temperature 32°F to 156. 2°F with Station: Indoor 0. 2°F resolution. (0°C to 69. 0°C with 0. 1°C resolution). [. . . ]