User manual LA CROSSE TECHNOLOGY WS-7016U

[. . . ] WS-7016U Wireless 433 MHz Temperature Station Instruction Manual TABLE OF CONTENTS Topic Inventory of Contents Additional Equipment Quick Setup Detailed Setup Guide Battery Installation Remote Control Sender Indoor Temperature Station Setting the Time Selecting Units of Measurement Features Indoor Minimum and Maximum Temperatures Outdoor Minimum and Maximum Temperatures Resetting the Indoor Minimum and Maximum Temperatures Resetting the Outdoor Minimum and Maximum Temperatures Reading the Temperature Trend Mounting 1 Page 1 1 2 3-6 3-4 5-6 7-8 8 9 10-11 11-12 12 13 2 Remote Control Sender Indoor Temperature Station Using Multiple Remote Control Senders Setup of Multiple Units Viewing Remote Control Senders Features of the Multiple Remote Control Senders Troubleshooting Maintenance and Care Instructions Specifications Warranty Information FCC DISCLAIMER 13-16 16-18 18-21 21-22 22-23 24-28 28-29 29-31 31-33 34 5. Instruction Manual and Warranty Card. Figure 1 Figure 2 INVENTORY OF CONTENTS 1. The Indoor Temperature Station (Figure 1) 2. The Outdoor Remote Control Sensor (TX3U) and mounting bracket. One strip of double sided adhesive tape. ADDITIONAL EQUIPMENT (not included) 1. [. . . ] After 15 seconds the "OUTDOOR MAX, " and "TIME" will stop flashing, and the maximum outdoor temperature will continue to be displayed. To return to current temperature, press and hold the OUTDOOR button for 1 second. V. RESETTING THE MINIMUM AND MAXIMUM TEMPERATURES A. To reset both the minimum and maximum temperatures--press and continue to hold the INDOOR button, while you press and hold the RESET button. When the temperatures are reset release the buttons. 14 2. To return to the current indoor temperature, press and hold the INDOOR button two times, holding for 1 second each. 1. To reset both the minimum and maximum temperatures--press and continue to hold the OUTDOOR button, while you press and hold the RESET button. When the temperatures are reset release the buttons. To return to the current outdoor temperature, press and hold the OUTDOOR button two times, holding for 1 second each. The temperature trend indicator is displayed in the OUTDOOR LCD. 15 Indicates that the temperature is rising. Indicates that the temperature is dropping. The absence of an arrow indicates that the temperature is stable. VII. THE REMOTE CONTROL SENDER Note: To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Control Sender. We recommend that you mount the Sender on a North-facing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their desired location before permanently mounting the Remote Control Sender. There should be a change of temperature in the OUTDOOR LCD within 6 minutes. 16 The Remote Control Sender can be mounted in two ways: with the use of screws or, using the adhesive tape. MOUNTING WITH THE SCREWS a) Remove the mounting bracket from the Remote Control Sender (figure 2). b) Place mounting bracket over desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. [. . . ] Continue to press RESET until you return to the first Remote Control Sender. B. VIEWING MULTIPLE REMOTE CONTROL SENDERS ON THE INDOOR TEMPERATURE STATION 1. To view the temperature of a different Remote Control Sender, press the RESET button. In the OUTDOOR LCD a 2 should shift and become a This indicates that you are C. [. . . ]