User manual LA CROSSE TECHNOLOGY WS-7044UA

[. . . ] Replace the battery cover. 2. 3. 4 B. Pull up and Cover out from the slot located in the central position of the battery cover. Observing the correct polarity, install 2 AAA batteries. The batteries will fit tightly (to avoid start-up problems make sure that they do not spring free during installation). [. . . ] VIEWING THE MINIMUM/MAXIMUM TEMPERATURES 1. Press the circular MIN/MAX button (under all LCD displays) once. An arrow will appear and point to the "MIN" that is printed in the right-hand margin. The minimum-recorded temperature will display in the OUDOOR LCD. Press the MIN/MAX a second time and the arrow will shift to point to the "MAX" that is printed in the right-hand margin. The maximum-recorded temperature is now displayed in the OUTDOOR LCD. Press the MIN/MAX a third time, and the OUTDOOR LCD returns to display the current outdoor temperature. 14 B. RESETTING THE MINIMUM/MAXIMUM TEMPERATURE 1. Press and hold the MIN/MAX button for 3 seconds. This will reset all records to the current outdoor temperature. MOUNTING Note: Extreme and sudden changes in temperature will decrease the accuracy of the Weather Temperature Station, and changes in elevation will result with inaccurate weather forecasting for the next 12 to 24 hours. These changes will require a 12 to 24 hour wait before obtaining reliable data. To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Temperature Sensor. We recommend that you mount the Remote Temperature Sensor on a North-facing wall. The sending range is 80ft (25m)--obstacles such as walls, concrete, and large metal objects can reduce the range. Place both units in their 15 desired location, and wait approximately 10 minutes before permanently mounting to ensure that there is proper reception. The Weather Temperature Station should display a temperature in the OUTDOOR LCD within 3 minutes of setting-up. THE REMOTE TEMPERATURE SENSOR The Remote Temperature Sensor can be mounted in two ways: · with the use of screws, or · using the adhesive tape. Remove the mounting bracket from the Remote Temperature Sensor. Place the mounting bracket over the desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. Where marked, start the screw holes 16 2. 3. 4. 5. into the mounting surface. Screw mounting bracket onto the mounting surface. [. . . ] Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. 22 La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. [. . . ]