User manual LA CROSSE TECHNOLOGY WS-7054U

[. . . ] WS-7054U Wireless 433 MHz Temperature Station Instruction Manual i TABLE OF CONTENTS Topic Inventory of Contents Additional Equipment Quick Setup Detailed Setup Guide Battery Installation Remote Control Sender Indoor Temperature Station Setting the Time Selecting Units of Measurement Features Indoor Minimum and Maximum Temperatures Outdoor Minimum and Maximum Temperatures Resetting the Indoor Minimum and Maximum Temperatures Resetting the Outdoor Minimum and Maximum Temperatures Reading the Temperature Trend Mounting Page 1 1 2 3-6 3-4 5-6 7-8 8 9 10-11 11-12 12 13 ii Remote Control Sender Indoor Temperature Station Using Multiple Remote Control Senders Setup of Multiple Units Viewing Remote Control Senders Features of the Multiple Remote Control Senders Troubleshooting Maintenance and Care Instructions Specifications Warranty Information FCC DISCLAIMER 13-16 16-18 18-21 21-22 22-23 24-28 28-29 29-31 31-33 34 iii INVENTORY OF CONTENTS 1. The Indoor Temperature Station (Figure 1) The Outdoor Remote Control Sensor (TX3U) and mounting bracket. (Figure 2) 3 each, 1/2" Philips screws. One strip of double sided adhesive tape. [. . . ] The absence of an arrow indicates that the temperature is stable. THE REMOTE CONTROL SENDER Note: To achieve a true temperature reading, avoid mounting where direct sunlight can reach the Remote Control Sender. We recommend that you mount the Sender on a North-facing wall. The sending range is 80ft; obstacles such as 13 walls, concrete, and large metal objects can reduce the range. Place both units in their desired location before permanently mounting the Remote Control Sender. There should be a change of temperature in the OUTDOOR LCD within 6 minutes. The Remote Control Sender can be mounted in two ways: · with the use of screws or, · using the adhesive tape. MOUNTING WITH THE SCREWS a) Remove the mounting bracket from the Remote Control Sender (figure 2). b) Place mounting bracket over desired location. Through the three screw holes of the bracket, mark the mounting surface with a pencil. 14 Where marked, drill holes into mounting surface using an appropriate size drill bit. d) Screw mounting bracket onto the mounting surface. Ensure that the screws are flush with the bracket. MOUNTING WITH ADHESIVE TAPE a) With a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. b) Remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket. 15 c) c) Remove the protective strip from the other side of the tape. Position the Remote Control Sender in the desired location, ensuring that the Indoor Temperature Station can receive the signal. B. THE INDOOR TEMPERATURE STATION Before mounting the Indoor Note: Temperature Station make sure that it is able to receive signals from the Remote Control Sender. The Indoor Temperature Station can also be mounted in two ways: · with the table stand or, · on the wall with the use of a wall hanging screw (not included). 16 1. USING THE TABLE-STAND a) The Indoor Temperature Station comes with the table stand already mounted. If you wish to use the tablestand all that is required is to place the Indoor Temperature Station in an appropriate location. 2. WALL MOUNTING 17 a) Remove the table stand. [. . . ] for both units Dimensions: (L x W x H) 30 Indoor Station Temperature 3. 51 x 1. 19 x 4. 88 in. (excluding table stand) (90 x 30. 5 x 125 mm). (56 x 24 x 80 mm). Remote Control Sender WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. [. . . ]