User manual LA CROSSE TECHNOLOGY WS-7098U

[. . . ] Outdoor temperature sensor World Time Center Introduction · · · · Remote transmission of outdoor temperature via 433MHz to base World Time Center. LCD display showing current outdoor temperature in Fahrenheit (ºF) Shower proof casing Wall mounting case Getting started Congratulations on purchasing this state-of-the-art World Time Center as an example of superior design and engineering. Providing radio controlled time, indoor temperature and humidity displays, outdoor temperature, this unit will never keep you guessing on time, date or current and future weather conditions. Operation of this product is simple and straightforward. [. . . ] Note: The year can be selected sequentially from 1998 to 2020 and will then start over again. The year furthermore will only be visible on the display of LCD 1 in programming mode. Press the "SET" key to switch to the mode "Worldtime Location Setting". 3. 12/24 hour setting Time setting Weekday setting Month setting Date setting Year setting World Time location setting World Time setting ºC or ºF setting LCD contrast setting Worldtime Location Setting 1. The dash representing the first character of the worldtime location (Default setting - - -) on LCD 1 will start flashing. Select the desired character by use of the "+" key. Press the "SET" key to move to the second character. Select the desired character by use of the "+" key. Press the "SET" key to switch to the third character. Select the desired character by use of the "+" key. Note: For designation of the worldtime location the characters "A" through "Z" and "0" as well as "-" and " " (Space) can be chosen. Press the "SET" key to move to the mode "World Time Setting". Note: If in programming mode no key is pressed for appr. To reset all data perform a basic setup as described in "Reset" above. Data Reception Criteria for Reception For reception and computing of displayed values, the software of the World Time Center performs a number of comprehensive operations (see Index) which are not necessarily important for the user to know. In case the time is not correctly displayed on LCD 2, then please see " WWVB Reception Check". WWVB-Signal Test The World Time Center will automatically start scanning for the WWVB frequency signal (time signal transmission) after the batteries are inserted. at a safe distance from interferring sources such as TV sets), it takes between 3 to 5 minutes to receive the signal. If after 10 minutes of inserting the batteries the WWVB signal is not properly received then check the following list before manually setting the time (see "Time Setting") in programming mode. The distance of the units should be at least 1. 5 - 2. 0 Meters away from interferring sources such as computer monitors or TV sets. Avoid placing the units onto or in the immediate proximity of metal window frames. Within thick concrete rooms such as basements and tower blocks, the WWVB frequency signal is naturally weaker for reception. In extreme cases, place the unit closer to a window and/or point its front or rear towards the general direction of NIST Radio Station WWVB in Ft. [. . . ] If the weather is sunny and the indicator is pointing upwards, it means that the weather is expected to continue being fine. : : : : : : : WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. [. . . ]