User manual LA CROSSE TECHNOLOGY WS-7213U

[. . . ] WS-7213U Wireless 433 MHz Weather Station Instruction Manual TABLE OF CONTENTS Topic Inventory of Contents Additional Equipment Quick Setup Detailed Setup Guide Battery Installation Setting the Time Features Minimum and Maximum Temperatures Resetting Minimum and Maximum Temperatures Weather Forecast and Weather Tendency Arrows Adding additional remote temp/humidity sensors (optional) Viewing and operating multiple remote temp/humidity sensors Mounting Troubleshooting Maintenance and Care Specifications Warranty Information Page 3 4 5-8 9-11 11 12-13 13 14-17 17-19 19-20 21-22 23-26 26 27-28 29-31 2 INVENTORY OF CONTENTS 1. The indoor weather Figure 1 station (Figure 1) 2. The remote temperature/humidity sensor (TX4U) and mounting bracket. Instruction Manual and Warranty Card. Figure 2 3 ADDITIONAL EQUIPMENT (not included) 1. [. . . ] It will not change from "sunny" directly to "rainy", although it is possible for the change to occur quickly. If the symbols do not change then the weather has not changed, or the change has been slow and gradual. Weather Tendency Arrows Other possible displays in the FORECAST LCD are 2 weather tendency arrows, one that points up (on the left side of the LCD) and one that points down (on the right side of the LCD). These arrows reflect current changes in the air pressure. An arrow pointing up indicates that the air pressure is increasing and the weather is expected to improve or remain good. An arrow 16 pointing down indicates that the air pressure is decreasing and the weather is expected to become worse or remain poor. No arrow means the pressure is stable and the weather should remain relatively the same D. ADDING ADDITIONAL REMOTE TEMP/HUMIDITY SENSORS (OPTIONAL) The WS-7213U is able to receive signals from 3 different remote temperature, temperature/humidity sensors. Following are some brief instructions for the basic set-up of remote sensor units with the WS-7213U. These extra sensors can be purchased through the same dealer as this unit, or by contacting La Crosse Technology directly. A TX6 will monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, the TX3UP will 17 monitor the temperature via a probe for use in pools, spas, etc and the TX4U will monitor temperature and humidity. Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote sensor units, and in numeric sequence. Second, install batteries into the indoor weather station. Transmission problems will arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. 1. It is necessary to remove the batteries from all units currently in operation. 2. Remove the battery covers to all remote sensor units. 3. Place all remote sensor units in a numeric sequential order. 4. In sequential order, install batteries (follow the same battery installation 18 procedures seen in section "I" of the Detailed Set-Up Guide) into the remote sensors. Install batteries into the indoor weather station. Follow the Detailed Set-Up Guide for programming and operating instructions. E. VIEWING AND OPERATING WITH MULTIPLE REMOTE SENSOR UNITS 1. To view the temperature of a different remote sensor unit, press and release the "CH" button. [. . . ] Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. [. . . ]