User manual LA CROSSE TECHNOLOGY WS-8120U-IT

[. . . ] Rechargeable batteries should be fully charged before inserting into clock. Alkaline rechargeable batteries must be used. If you choose to use non-rechargeable batteries, the battery switch MUST be moved to the BATTERY position (not the SOLAR position). In this position, the solar cells do not charge the batteries. [. . . ] By use of the + key select "ON" or "OFF" to set the solar mode. Press and release the SET key to exit the setting mode and switch back to the normal display mode. If the solar mode setting is ON: The surrounding environment brightness is checked every 5 seconds LCD will automatically turn OFF if the environment is too dark LCD will automatically turn ON if the environment is bright enough No information will be displayed when the LCD is OFF, but all the settings and operations will remain, except for the temperature and humidity measurements. If the solar mode setting is OFF: Please help in the preservation of the environment and return used batteries to an authorized depot. SETUP AFTER CHANGING/REPLACING THE BATTERY IN THE SOLAR CLOCK 1. After powering up the Solar Clock, all LCD segments will light up briefly and it will show the time (12:00), indoor temperature, date, and indoor humidity. After the batteries are inserted, the Solar Clock will start receiving data signal from the solar transmitter. The outdoor temperature data should then be displayed on the Solar Clock. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1. The distance between the Solar Clock and the transmitter should not be more than 200 feet (60m) to ensure sufficient 915 MHz transmission. (see notes on "Positioning" and "915 MHz Reception"). Be careful that it does not spring free from the contacts. Press any button 20 times with the battery removed. Always wait at least 10 minutes after removing battery before re-inserting; otherwise start up problems may occur. 2. LCD will remain ON constantly. 3. STOP MODE If the Solar Clock is placed in a dark environment for 72 hours continually, the clock will go to the stop mode: The most power saving condition. The Solar Clock will not perform any operation and the LCD will also be OFF. Users need to press any key to wake up the Solar Station and to reactivate the transmission with the solar transmitter. VIEW MIN/MAX READINGS: Press and release the PLUS button to view outdoor MIN/MAX readings, then indoor MIN/MAX readings then return to the normal display. TO SET THE TIME Note: the time will be displayed with "AM" or "PM" for the time from 12:00 until 11:59. Press and hold the SET key for 3 seconds to enter the time setting mode. 5 RESET MIN/MAX READINGS: Press and hold the PLUS button for 5 seconds to reset both Indoor and Outdoor MIN/MAX readings to current temperature. 6 DISPLAY MODES: Press and release the SET button to change the way the temperatures are displayed on the weather station: There are two possible ways to mount the solar clock: use of the foldable table stands, or wall mounting WALL MOUNTING 1. Install a mounting screw (not included) into a wall--leaving approximately 3/16 of an inch (5mm) extended from the wall. Place the Solar Clock onto the screw, using the hanging hole on the backside. Gently pull the Solar Clock down to lock the screw into place. Note: Always ensure that the Solar Clock locks onto the screw before releasing. Shows: Outdoor temperature in the first line on the left side. Shows: Indoor temperature in the first line on the right side and Indoor humidity in the second line on the right side. [. . . ] This warranty gives you specific legal rights. You may also have other rights specific to your State. Some States do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information contact: The complete instruction manual is available at: www. lacrossetechnology. com/support Le manuel d'instruction complet est disponible sur: www. lacrossetechnology. com/support El manual de instrucciones completo está disponible en: www. lacrossetechnology. com/support All rights reserved. [. . . ]