User manual LA CROSSE TECHNOLOGY WS6118

[. . . ] Avoid using rechargable batteries. SETTING UP: 1. Insert the 2 x AA, IEC LR6, 1. 5V batteries into the transmitter (See "To install and replace batteries in the Temperature Transmitter" above). Within 3 minutes, insert 2 x AA, IEC LR6, 1. 5V batteries into the Moonphase wall clock as indicated above (see "To install and replace batteries in the Moonphase wall clock" above). Once the batteries are in place, all segments of the LCD will light up briefly. [. . . ] Press and release the SET key to move to the "Year Setting". YEAR SETTING The year can be selected sequentially from 2001 to 2029 and will then start over again (default setting 2006). Only the last 2 digits of the year will be visible on LCD2 . The year digits will start flashing on LCD2. Select the desired year by use of the + key. Press and release the SET key to switch to the "Month Setting". MONTH SETTING 1. The month digits on LCD2 will start flashing (Default setting 1). Set the desired month by use of the + key. Press and release the SET key to move to the mode "Date Setting". 20 DAY SETTING 1. The digits for the day will start flashing on LCD2 (Default setting 1). Set the desired day by use of the + key. Note: The day can only be set in conjunction with the selected month. For example, it is not possible to set the data 30 if the months of February is selected. Press and release the SET key to enter the "Weekday Setting". The weekday symbols will be displayed on LCD2 in the pre-set language and flashing. Set the desired weekday by use of the + key. Press and release the SET key to enter the mode "12/24 Hours Time Display Setting". The "12h" or "24h" will start flashing in LCD1 (Default setting 24h). Select the desired time display mode by use of the + key. Press and release the SET key to enter the "ºC/ºF Temperature Setting". The characters "° or "° will start flashing on LCD1 (Default setting ° B y use of the C" F" C). + key select "° for temperature display in degrees Celsius or "° for degrees C" F" Fahrenheit. Press and release the SET key to exit the setting mode and switch back to the normal display mode. 2. [. . . ] Disposal of electronic waste in wild country and/or in unauthorized grounds strongly damages the environment Please contact your local or/and regional authorities to retrieve the addresses of legal dumping grounds with selective collection All electronic instruments must from now on be recycled. User shall take an active part in the reuse, recycling and recovery of the electrical and electronic waste. The unrestricted disposal of electronic waste may do harm on public health and the quality of environment. This product must however not be thrown in general rubbish collection points. [. . . ]