User manual LA CROSSE TECHNOLOGY WS9117

[. . . ] The outdoor temperature should then be displayed on the Temperature station. If this does not happen after 2 minutes, the batteries will need to be removed from both units and reset from step 1. In order to ensure sufficient 868 MHz transmission however, the distance between the Temperature Station and the transmitter should not be more than 100 meters (see notes on "Positioning" and "868 MHz Reception"). 50 WHEN MORE THAN ONE TRANSMITTER IS USED 1. [. . . ] Replace the battery cover on the unit. 57 Note : In the event of changing batteries in any of the units, all units need to be reset by following the setup procedures. This is because a random security code is assigned by the transmitter at start-up and this code must be received and stored by the Temperature Station in the first 3 minutes after power supplying. BATTERIES REPLACEMENT & MAINTENANCE: For best performance, batteries in all units should be replaced at least once every 2 years to maintain optimum running accuracy. Ensure that the batteries used are new of from the correct size. 58 Please help in the preservation of the environment and return used batteries to an authorized depot. 59 LCD SCREEN The Temperature Station's LCD is split into 3 sections and once the batteries are inserted, all the segments will light up momentarily before displaying : 1. Time "0:00" Indoor and outdoor temperature in degree Celsius (°C) or Fahrenheit (°F) 60 Time Indoor Temperature in °C or °F Outdoor Temperature in ºC or °F Transmitter identification No. Outdoor Transmission Signal* 61 *When the signal is successfully received by the Temperature Station, the outdoor transmission icon will be switched on. (If not successful, the icon will not be shown on LCD) So the user can easily see whether the last reception was successful (icon on) or not (icon off). On the other hand, the short blinking of the icon shows that a reception is currently taking place. 12 or 24 hour setting: After the batteries are inserted, set the time display as follow : 1. Press and hold the "SET/CH" key for about 3 seconds to enter the set mode 62 2. 3. 4. Either a ": 12h" or ": 24h" will appear on the LCD. If ": 12h" is displayed then the current time display is set to 12-hour time. If ": 24h" is displayed then the current time is set to 24-hour time. To alternate between the two times display mode, simply press the "MIN/MAX/+" key. When the desired time display is selected, press the "SET/CH" key once more to enter the Celsius or Fahrenheit degree setting mode. Note : When the time display is set to 12-hour mode, the temperature unit will be fixed to °F; when the selected time mode is 24-hour, the temperature unit will be fixed to °C. 63 CELSIUS OR FAHRENHEIT DEGREE SETTING: Following from the 12 or 24 hour setting mode. Either a "°C" or "°F" will appear on the LCD. If "°C" is displayed then the current temperature reading is set to Celsius. If "°F" is displayed then the current temperature reading is set to Fahrenheit. To alternate between the two temperature reading modes, simply 2. Press "SET/CH" key to confirm and enter the time setting mode. TIME SETTING : Following from the Celsius or Fahrenheit degree mode. 64 1. [. . . ] User shall take an active part in the reuse, recycling and recovery of the electrical and electronic waste. The unrestricted disposal of electronic waste may do harm on public health and the quality of environment. As stated on the gift box and labeled on the product, reading the "User manual" is highly recommended for the benefit of the user. [. . . ]