User manual LA CROSSE TECHNOLOGY WT-8112U

[. . . ] Use switch to select which type of battery will be HOW TO SET THE TIME MANUALLY In case the radio-controlled clock is not able to detect the WWVB-signal used before (disturbances, transmitting distance, etc. ); the time can be manually set. The clock inserting the battery into the will then work as a normal Quartz clock. compartment Note: the time will be displayed with an additional "PM" for the time from 12:00 noon until 11:59. Note: The unit will still try to receive the signal every day despite it being manually set. [. . . ] REGARDLESS OF THE TYPE OF BATTERY INSTALLED, THE BATTERY SWITCH MUST BE IN THE BATTERY POSITION WHEN THE BATTERY IS INSERTED. If a rechargeable battery is used, the Battery switch should be moved to the SOLAR position AFTER it is has been inserted. To use the included rechargeable Alkaline battery (charged by solar panel): 1. It is important to allow sufficient light to reach the solar panel while activating the solar clock. Make sure the lights are on in the setup room and the solar panel is facing a 60W light bulb or brighter - do not cover with hands or other objects. Remove the black protective foil on the solar panel. DO NOT SET THE CLOCK. YEAR The year can be selected sequentially from 2001 to 2029 and will then start over again (default setting 2009). The year will only appear in the manual setting mode. The year digits will start flashing (only last 2 digits) on LCD2. Select the desired year by use of the + key. Press and release the SET key to switch to the "Month Setting". MONTH 1. The month digit on LCD2 will start flashing (Default setting 1). Set the desired month by use of the + key. Press and release the SET key to move to the mode "Date Setting". The digits for the date will start flashing on LCD2 (Default setting 1). Set the desired date by use of the + key. Note: The date can only be set in conjunction with the selected month. For example, it is not possible to set the date 30 if the month of February is selected. Press and release the SET key to move to "Weekday setting". The weekday symbols will be displayed on LCD2 in the pre-set language and flashing. Set the desired weekday by use of the + key. Press and release the SET key to enter the mode "12/24h Time Format Setting". MANUAL SETTINGS Note: If the radio-controlled clock has already successfully received the WWVB time signal and displays the correct time and date, then the Manual settings can be skipped. [. . . ] This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request as proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd's authorized service center. All rights reserved. [. . . ]