User manual LA CROSSE TECHNOLOGY WT5160

[. . . ] After approximate 3 to 5 minutes, the DCF time will be displayed Note: User shall also refer to Manual Setting for detailed Setting up procedures. 33 Important! Use only the adapter provided with the projection clock and make sure that your household voltage is appropriate to the working voltage of the transformer. Otherwise your projection clock may be damaged. · Radio controlled time receiver is at the bottom side of the main unit. Don't place the adapter wire adjacent to the bottom side of the main unit when AC power is used, as this may decrease the reception sensitivity. 34 BATTERIES POWERED WITH THE USE OF AC/DC ADAPTER If the Projection clock is first powered by batteries and the power adapter is subsequently used for extended period of time, the main power source of the Projection clock will switch to AC/DC power. The batteries will then act as a backup power source in case of power failure. [. . . ] Then user shall press and hold the MODE/MIN key and at the same time place the batteries into the clock. Then there will be a beep sound and the flashing time zone digits "0 h" will be displayed. User may now press shortly the MODE/MIN key to set the time zone between +9 and -9 hours (The time zone default of the Projection clock is "0 hour"). flashing 41 Then confirm with the SNOOZE key and enter the Manual time setting. Note: If AC adaptor is used instead of battery, user shall first connect the adaptor to the wall socket, then press and hold the MODE/MIN key and finally insert the power cable to the jack of the clock. User shall keep on holding the MODE/MIN key until the time zone flashing digit "0h" is displayed on LCD. Manual time setting In case the Projection clock cannot detect the DCF-signal (for example due to disturbances, transmitting distance, etc. ), the time can be manually set. The clock will then work as a normal Quartz clock. Hour flashing Minutes flashing 42 1. The hour and the minute digits will start flashing. Use the AL/HOUR key to set the hour; MODE/MIN key to set the minute. Confirm with the SNOOZE key and enter the Calendar setting. Note: · The unit will still try and receive the signal every one hour despite it being manually set. When it does receive the signal, it will change the manually set time into the received time. Also the manually-set date and weekday will be changed to the received date. · The time is displayed in 24-hour format. CALENDAR SETTING : The date default of the Projection clock is 1. Once the radiocontrolled time signals are received, the date is automatically updated. However, if the signals are not received, the date can also be set manually. Use the MODE/MIN key to set the year (the range runs from 2000 to 2049). 43 flashing 2. 3. Press the MODE/MIN key to set the year (between year 2000-2049). Press the SNOOZE key again to confirm and to enter the month and day setting. The month and day digits will start flashing. Day (flashing) Month (flashing) 44 4. 5. Press the AL/HOUR key to set the day and MODE/MIN key to set the month. Press the SNOOZE key again to confirm and to enter the Weekday setting mode. [. . . ] · Avoid exposure to sudden changes in temperature such as direct sunlight, extreme cold and wet or moist conditions. · When cleaning the display and casing, only use a soft damp cloth. Do not use solvents or souring agents as they may mark the LCD and casing. · Do not submerge the alarm clock in water. [. . . ]