Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual LAE ELECTRONIC AT2-5. We hope that this LAE ELECTRONIC AT2-5 user guide will be useful to you.
Lastmanuals help download the user guide LAE ELECTRONIC AT2-5.
Detailed instructions for use are in the User's Guide.
[. . . ] With ALR=0 the low temperature alarm is excluded. When the compressor operation time, expressed in weeks, matches the ACC value programmed, "CL" flashes in the display. With ACC=0 the condenser cleaning warning is disabled. [. . . ] AL0 : contacts open when an alarm condition occurs. AL1 : contacts make when an alarm condition occurs. With INP = SN4, the probes must be the LAE models SN4. ; with INP = ST1, the probes must be the LAE models ST1. TLO Minimum probe 1 temperature recorded CND Compressor working weeks LOC Keypad state lock The output is switched on again after CRT minutes have elapsed since the previous switchover. With CT1=0 the output will always remain OFF. To exit from the menu, press button X or wait for 10 seconds. While keeping button pressed, use button X . SETPOINT (display and modification of desired temperature value) Press button for at least half second, to display the setpoint value. By keeping button pressed, use button or to set the desired value (adjustment is within the minimum SPL and the maximum SPH limit). When button is released, the new value is stored. STAND-BY Button , when pressed for 3 seconds, allows the controller to be put on a standby or output control to be resumed (with SB=YES only). KEYPAD LOCK The keypad lock avoids undesired, potentially dangerous operations, which might be attempted when the controllers is operating in a public place. SELECTION OF SECOND PARAMETER GROUP It's possible to select control parameters between two different pre-programmed groups, in order for the fundamental control parameters to be adapted quickly to changing needs. With IISM=MAN, changeover from Group I to Group II takes place for 2 seconds. Defrosting starts automatically when necessary time has elapsed to obtain the defrosting frequency set with DFR (IIDF). For example, with DFR=4 defrosting occurs once every 6 hours. The internal timer is set to zero when power is applied to the controller and at each subsequent defrost start. [. . . ] Once defrost has started, Compressor and Defrost outputs are controlled according to the parameters DTY and OAU. the AUX output is associated to defrost function with OAU=DEF exclusively. If FID=YES the evaporator fans are active all through defrost. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE LAE ELECTRONIC AT2-5
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual LAE ELECTRONIC AT2-5 will begin.
