User manual LANIER AFICIO SP 4110N

[. . . ] Operating Instructions Hardware Guide 1 2 3 4 5 6 7 8 9 Guide to the Printer Installing Options Connecting the Printer Configuration Paper and Other Media Replacing Consumables and Maintenance Kit Cleaning the Printer Adjusting the Printer Troubleshooting 10 Removing Misfed Paper 11 Appendix Read this manual carefully before you use this machine and keep it handy for future reference. For safe and correct use, be sure to read the Safety Information before using the machine. Introduction This manual contains detailed instructions and notes on the operation and use of this machine. For your safety and benefit, read this manual carefully before using the machine. Keep this manual in a handy place for quick reference. [. . . ] · p. 25 "Attaching Envelope Feeder Type 400" · p. 78 "Types of Paper and Other Media" Loading envelopes onto the bypass tray · Confirm that the envelope flaps are securely folded down, and that there is no air inside the envelopes. 100 Loading Paper 1. Load envelopes until they stop, with the print side up and the sides of the flaps on the left as shown below. AUB260S 2. Slide the side guides against the edge of the envelope stack. Set the envelope size and feed direction. Press the [Menu] key. 5 AUB051S The [Menu] screen appears. Press the [ ] or [ ] key to display [Paper Input], and then press the [ Enter] key. 5. Check [Bypass Size] appears, and then press the [ Enter] key. Press the [ ] or [ ] key to select the envelope type, and then press the [ 7. · Confirm that the top of the stack is not higher than the limit mark on the side guides. Paper and Other Media · Do not push the stack of envelopes with too much force. · Confirm that the edges of envelopes fit under the side guides. · p. 78 "Types of Paper and Other Media" Loading envelopes into the envelope feeder unit The following explanation uses the example of installing the envelope feeder unit in "Tray 2". · Even if the optional envelope feeder is not installed, you can select envelope sizes for Tray 2 and Tray 3 using the control panel. However, you cannot load envelopes until the optional envelope feeder unit is installed. 5 · With the optional envelope feeder unit, you can load up to 60 envelopes at the same time. · Confirm that the envelope flaps are securely folded down, and that there is no air inside the envelopes. · Do not slide the paper tray in with force. If you do, the front and side guides might move. Pull the optional paper feed unit (Tray 2) out until it stops. Then, lift it slightly, and then slide it out. AUB261S 2. Prepare the envelope feeder unit. 102 Loading Paper 3. Pinch the side guides, and then slide them outward until they stop. Pinch the rear guide, and then slide it toward the back. ZGDY260E 4. [. . . ] Paper Output Capacity: Standard 250 sheets (80 g/m2, 20 lb. ) Paper Input Capacity: Standard Paper Tray Bypass Tray *2 Optional Paper Feed Unit 500 sheets *1 100 sheets *1 500 sheets × 2 *1 189 11 11. Appendix Optional Envelop Feeder Unit *3 *1 Paper weight: 60 - 130 g/m2 (16 - 34 lb. ) 60 sheets *1 *2 You can load up to 10 envelopes (55 - 157 g/m2, 14 - 42 lb. ) at the same time. *3 To use the envelope feeder unit, the optional paper feed unit is required. The paper tray of the feed unit can be replaced with the envelope feeder unit. [. . . ]