User manual LASERLINE 211UK

[. . . ] cod. : ISUT211/211BUK-UK FILENAME:ISUT211/211BUK-UK. P65 GB 211UK -211BUK MODULAR ALARM SYSTEMS USER GUIDE ® CAR ALARM SYSTEMS THE SYSTEM IS MANUFACTURED FROM THE HIGHEST QUALITY COMPONENTS TO ENSURE A LONG TROUBLE FREE OPERATING LIFE. THESE INSTRUCTIONS ARE INTENDED TO FAMILIARISE YOU WITH THEIR VERY SIMPLE OPERATION. KEY * Optional. *** 211BUK only NO DANGER FOR USER DUE TO THE RADIOFREQUENCY EXPOSURE! WARNING ALARMS MUST NOT BE STEAM CLEANED OR PRESSURE WASHED. BEFORE CARRYING OUT ANY ELECTRICAL WORK ON THE VEHICLE ISOLATE THE SYSTEM BY REMOVING SYSTEM FUSE/VEHICLE BATTERY OR DAMAGE TO THE ALARM MAY RESULT! OPERATING INSTRUCTIONS You would have received from your installer, two remote controls (see fig. [. . . ] PASSIVE ARMING * This function allows the alarm to be armed automatically without using the remote control: Turn off the ignition key and exit the vehicle. 10 seconds after the last door is closed/or 10 seconds after the courtesy lights go out the alarm will arm (the function does not activate the power locking system and the accessory output). Please ensure you lock the doors using the normal ignition key!SAFETY LOCKING* This function automatically closes the power locking system in the following situation: Disarm the alarm with the remote control or electronic key. Enter vehicle and only after having closed all the protected areas (doors/boot/bonnet), turn the ignition key ON. The power locking system will automatically lock the doors after 5 seconds. The doors will unlock automatically when the ignition key is turned OFF. IMPORTANT NOTE: Only to be used if the car is equipped with an original "crash sensor" (inertia switch) power locking system that is activated if an accident occurs. If not, a similar one available on the market must be installed. will be not be held responsible if users do not comply with this note. SIREN EXCLUDING Disarm the alarm system using the remote control. Enter the vehicle and make sure that all doors/ bonnet/boot are closed. Turn the ignition key ON; within 5 seconds press button "B" of the remote control once. At the same time that you press button "B", you will hear a brief audible tone to confirm the programming. Now the siren sound is temporarily excluded and if an alarm condition occurs, only the direction indicator lights will flash. This function may be necessary in hospital parking areas, ferries, skiing resorts etc. The function will be reset the next time the alarm is armed using the remote control or an electronic key. ATTENTION: excluding the siren does not deactivate the additional siren/vehicle horn/paging system and the panic function. BATTERY BACKUP SIREN*** If the alarm system power supply is removed (e. g. disconnection of vehicle battery) will cause an immediate alarm condition. Note: For servicing of vehicle battery, disarm the alarm before disconnecting vehicle battery. ADDITIONAL SIREN* This function allows the alarm to be connected to an additional siren/vehicle horn/paging system and can be programmed to obtain a continuous or intermittent output for the entire alarm cycle. GARAGE FUNCTION This function allows the vehicle to be left in attended car parks or for vehicle servicing, without having to leave the remote controls or electronic keys*. The procedure to activate the GARAGE FUNCTION is described below: Within 5 seconds press button `A' on the remote control (arm/disarm) three times. [. . . ] If product is repaired by a non authorised installer the product will cease to be covered by the warranty. CONSUMER SUMMARY All warranties are limited to the duration of this warranty. This is the complete warranty and no other express or implied warranty is valid. Nothing in this warranty shall affect your statutory rights. [. . . ]