User manual LASERLINE 289

[. . . ] 288 - 289 ­ 29024V COMPACT ALARM SYSTEMS The system is manufactured from the highest quality components to ensure a long trouble free operating life. These instructions are intended to familiarise you with their very simple operation. OPERATING INSTRUCTIONS You should have received two "remote controls" and one override "electronic key*". The "electronic key" will be accepted by a LED/receptacle* that has been mounted in the dashboard. [. . . ] The doors will unlock automatically when the ignition key is turned OFF. IMPORTANT NOTE: Only to be used if the car is equipped with an original "crash sensor" (inertia switch) power locking system that is activated if an accident occurs. If not, a similar one available on the market must be installed. will be not be held responsible if users do not comply with this note. With the alarm disarmed, and all doors closed, turn the ignition key ON; Within 5 seconds press button `A' on the remote control (arm/disarm) three times. The LED on the dashboard will turn on each time the button "A" is pressed and at the same time, you will hear audible tones. Programming will be confirmed by a continuous audible tone and the direction indicator lights will flash at the same time. The audible tone and the flashing indicator lights will stop immediately after the car ignition is turned off. Now you can use the car for a maximum of 10 minutes. During this period, there will be a continuous audible tone and the direction indicator lights will flash at the same time. At the end of this period (10 minutes), the alarm system will arm itself and if the car is being used at that time, the system will activate the siren. If you want to exclude the GARAGE FUNCTION prior to the end of the 10 minutes, press button `A' of the remote control one time (arm/disarm) with the ignition key turned OFF. The direction indicator lights will flash once and you will hear on audible tone at the same time to confirm that the function has been excluded. AUTO-LEARNING Auto-learning function allows you to program new remote controls/electronic keys or cancel lost remote controls/electronic keys. To carry out the auto-learning procedure, at least one functioning remote control or electric key must be available. Open the door on the driver's side; # Turn the ignition key ON; $ Press and hold button "A" on the functioning remote control or insert and hold an electronic key into the receptacle. & Now turn off the ignition key and release button "A" or remove the electronic key from the receptacle. The red LED installed on the dashboard will turn on and remain on, indicating the auto-learning condition. ' At this point, press button "A" of all the remote controls or insert the electronic keys into the receptacle, that you want to store into the alarms memory. The red LED will turn off briefly for each remote control or electronic key that has been programmed into the alarm memory. ( To complete the auto-learning procedure either: Turn the ignition ON to exit the function. Wait 10 seconds for the LED to go out and then start to flash the emergency pin code (see the How to Know Your Emergency Pin Code paragraph). % % % You can program a maximum of 6 remote controls and 4 electronic keys. [. . . ] If product is repaired by a non authorised installer the product will cease to be covered by the warranty. Original manufacturer negligence. Consumer Details All warranties are limited to the duration of this warranty. This is the complete warranty and no other express or implied warranty is valid. Nothing in this warranty shall affect your statutory rights. IMPORTANT NOTE FAILURE TO COMPLETE AND RETURN THIS CARD WILL RESULT IN YOUR WARRANTY BECOMING VOID. CUSTOMER LIFETIME WARRANTY REGISTRATION Alarm/Immobiliser Model No. [. . . ]