User manual LASKO PH200

[. . . ] Avoid the use of extension cords because the extension cord may overheat and cause a risk of fire. However, if you have to use an extension cord, minimize the risk of overheating by ensuring that they are UL listed. The cord shall be a 3-wire, grounding type, with No. 14 AWG minimum size and rated not less than 1875 watts. [. . . ] Always use handle when moving this Heater. Keep combustible materials, such as furniture, pillows, bedding, papers, clothes and curtains at least 3 feet (0. 9 m) from the front of the Heater and keep them at least 1 foot (0. Do not use the Heater in areas where gasoline, paint, or flammable liquids are used or stored. It must NOT be used in potentially dangerous locations such as flammable, explosive, chemicalladen or wet atmospheres. This Heater is intended for general use ONLY. This Heater is not intended for use in wet or damp locations. This Heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate a Heater where it may fall into a bathtub or other water container. For ease of assembly, lay the Heater down so that the front grill and control panel are facing up. Carefully remove the Heater from the bag and the carton. Once the timer has been set, the timer will count down the hours in 1 hour increments, showing on the display the remaining operating time. The Heater will turn itself off when the set time has lapsed. The unit can be turned back on by pressing the Power Button ( ). Pressing the ( ) or ( ) Button will prompt the Heater into High heat and will allow the thermostat to be set at a desired temperature. When the air temperature reaches 3 degrees above the SET temperature, the heater will shut off. When the air temperature drops 1 degree below the SET temperature, the unit will turn on. All the functions performed with the Remote Control work identically to the manual controls, except that you are unable to change from °F to °C with the remote control. If you lose your remote control, please call Customer Service to order a replacement at 1-800-233-0268, Monday through Friday, between the hours of 8:00 a. When an overheat temperature is reached, the Heater will automatically shut off. It can only resume operation when the unit is reset. Unplug the Heater and wait 10 minutes for the unit to cool down. [. . . ] This product is warranted for three years from the date of purchase against defects in workmanship and/or materials. At our option, parts that prove to be defective will either be repaired or replaced or the whole product will be replaced. Should electrical or mechanical repair become necessary during the warranty period, send your complete product, postage or freight pre-paid to the nearest service center. Call the number below for the service station nearest you. [. . . ]